Cisco Expressway CE1000 Appliance Руководство по установке - Страница 8
Просмотреть онлайн или скачать pdf Руководство по установке для Шлюз Cisco Expressway CE1000 Appliance. Cisco Expressway CE1000 Appliance 16 страниц. X8.2 or later
Печатать страницу
Configuring
6 LAN 3 (not currently used)
7 LAN 4 (not currently used)
8 USB port
9 USB port
Figure 2: Front panel showing KVM connector.
The front panel port is:
1
KVM connector
Connecting via the serial port
To connect to the Cisco Expressway via the serial port:
1. Connect the Ethernet LAN cable from the LAN 1 port on the rear of the unit to your network.
The LAN 1 port is the left-hand port of the dual port adapter on the rear panel of the unit (shown in
Rear panel showing ports.
2. Connect a serial cable from the serial port on the rear of the unit to the serial port on a PC (see
Rear panel showing ports.
The serial cable used must be a cross-over cable. The pin assignment for the serial cable is:
Male RJ45 pin
1
2
3 TXD
4 GND
5 GND
6 RXD
7
8
Note: if there is no DB9 port on your PC, a DB9 to USB serial port adapter is required.
3. Start a terminal emulator program (for example PuTTY) on the PC and configure it to use the PC's serial
port as follows:
Cisco Expressway CE1000 Appliance Installation Guide (8.5)
[p.7]).
[p.7]).
Female DB9 pin
8
6
2
5
5
3
4
7
Figure 1:
Figure 1:
Page 8 of 16