Cisco Physical Access CIAC-GW-K9 Установка и настройка - Страница 10

Просмотреть онлайн или скачать pdf Установка и настройка для Шлюз Cisco Physical Access CIAC-GW-K9. Cisco Physical Access CIAC-GW-K9 26 страниц. Physical access gateway
Также для Cisco Physical Access CIAC-GW-K9: Краткое руководство по эксплуатации (17 страниц)

Cisco Physical Access CIAC-GW-K9 Установка и настройка
Installing the Cisco Physical Access Gateway
9
10
1. Wire colors are shown in parentheses.
2. Outputs show the LED color and reader wire color (in parentheses). For example, "GRN (orange)" supports a green LED.
Attach the orange wire from the reader device.
3. ---------- means the wire slot is not used.
Connect input devices to the Gateway:
Step 4
Insert two-pin connector plugs into the input ports (see
a.
(Optional, for supervised input connections only). Install two End-Of-Line (EOL) 1K termination
b.
resistors in each supervised input interface (one terminator in each connector).
terminator installation for a Normally Closed (NC) and Normally Open (NO) input connection.
Figure 2-6
Connect the wires from the input devices (see
c.
Note
Cisco Physical Access Gateway User Guide
2-10
Chassis
Label
Description
HCRD
Hold
Control
CP
Card
Present
Input Connections: Cisco Physical Access Gateway,Input and Reader Modules
1K,, 1%
1K,, 1%
Each of the input connections can be configured as supervised or unsupervised. The tamper and
power fail inputs can be configured as additional unsupervised ports. A supervised input
supports four states: normal, alarm, open and short. An unsupervised input indicates only normal
or alarm.
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
One Reader
First Reader in a
10 Wire Connection
5 Wire Connection
HCRD
(blue)
----------
CP
(purple)
----------
Figure
1K,, 1%
NC
1K,, 1%
NO
Figure
2-7).
Second Reader in a
5 Wire Connection
D1/CLCK (white)
D0
(green)
2-7).
Figure 2-6
shows the
OL-32499-01