Cisco TelePresence ISDN GW MSE 8321 Начало работы - Страница 6
Просмотреть онлайн или скачать pdf Начало работы для Шлюз Cisco TelePresence ISDN GW MSE 8321. Cisco TelePresence ISDN GW MSE 8321 17 страниц.
Также для Cisco TelePresence ISDN GW MSE 8321: Руководство по началу работы (15 страниц)
Печатать страницу
Installing the ISDN gateway
IMPORTANT
8000, and connecting the power supply, you must read the safety
information at
http://www.cisco.com/go/telepresence/safety
Although blades are hot-swappable parts, you must only remove one
!
blade at any time. Remove the power from the MSE 8000, if you need to
remove more than one blade at a time.
Before hot-swapping a blade, shut down the blade using the web
!
interface. Do not shut down a blade during a software upgrade or if the
blade is processing.
For information about powering the MSE 8000, refer to the Getting Started Guide on
http://www.tandberg.com/support/video-conferencing-documentation.jsp).
Step one: Install the ISDN gateway into the MSE 8000 chassis
You must install either a blade or a blanking blade in each of the ten
!
positions in the chassis.
The Supervisor blade must be installed into slot 1 of the MSE 8000
!
chassis.
1
Remove the blade or blanking blade from the slot into which you are going to
install the ISDN gateway:
i
Using a No.1 Phillips screwdriver, loosen the screws in the retaining latches
with an anti-clockwise quarter turn.
ii
Open both retaining latches on the front of the blade or blanking blade.
When open, a retaining latch is at a 90
the blade.
iii Slide out the blade or blanking blade.
2
Open both retaining latches on the front of the ISDN gateway. When open, a
retaining latch is at a 90
3
Slide the ISDN gateway into the blade slot (as shown in Figure 2) until it stops.
: Before installing the ISDN GW MSE 8321 into the MSE
angle perpendicular to the front of the blade.
°
Installing the ISDN gateway
.
angle perpendicular to the front of
°
6