Envelopes
1. Load up to 10 envelopes at a time, flap edge left, and
printable side up, against the right edge of the sheet feeder.
2. Slide the left edge guide against the envelopes (but not too
tightly).
Note:
For best results, press each envelope flat before loading, or load
one envelope at a time.
3. Select the following settings in your printer software:
❏ Plain paper as the Type (Windows
(Macintosh
) setting
®
❏ The correct envelope size as the Size (Windows) or
Paper Size (Macintosh) setting
❏ Landscape as the Orientation setting
Selecting the Correct Media Type
Select the Type (Windows) or Media Type (Macintosh)
setting according to these guidelines:
For this paper
Plain paper sheets or envelopes
EPSON Premium Bright White Paper
EPSON Iron-On Transfer Paper
EPSON Photo Quality Ink Jet Paper
EPSON Photo Quality Self Adhesive
Sheets
EPSON Matte Paper Heavyweight
EPSON Double-Sided Matte Paper
PremierArt Matte Scrapbook Photo Paper
for Epson
EPSON Photo Paper
EPSON Glossy Photo Paper
EPSON All-Purpose Glossy Photo Paper
EPSON Glossy Photo Greeting Cards
EPSON Premium Glossy Photo Paper
®*
EPSON Photo Stickers
EPSON Premium Luster Photo Paper
EPSON Premium Semigloss Photo Paper Premium Semigloss Photo
) or Media Type
®
Select this Type or Media
Type setting
Plain paper
Bright White Paper
360 dpi Ink Jet Paper
Photo Quality Ink Jet Paper
Matte Paper - Heavyweight
Photo Paper
Glossy Photo Paper
Premium Glossy Photo Paper
Premium Luster Photo Paper
Paper
10/03
EPSON Stylus Photo RX500
For this paper
EPSON ColorLife Photo Paper
EPSON Semigloss Scrapbook Photo
Paper
EPSON Ink Jet Transparencies
EPSON Photo Stickers*
*
You can use either Premium Glossy Photo Paper or Ink Jet Transparencies as
your Type or Media Type setting for Photo Stickers. Experiment to see which
setting gives you the best results.
Placing Your Original Document
1. Open the scanner lid.
2. Place your document face-down on the glass, in the corner
shown below. Move your document about 0.1 inch from
the top and side edge so your entire document is scanned.
3. Close the scanner lid.
Note:
If you place your document against the guides, the edges next to the
guides won't be scanned.
If you need to scan a thick document, such as a book, you can
remove the scanner lid. Press the P On button to turn the Stylus
Photo RX500 off, then unplug it. Open the scanner lid completely.
Then disconnect the cord from the TPU connector on the back of the
scanner and pull the lid straight up. Gently press down the original to
keep it flat on the document table. Be sure to replace the scanner lid
and reconnect the cord when you're finished.
Copying Without a Computer
Basic Copying
1. Place your document face-down on the glass, as shown in
the previous section.
2. Close the scanner lid.
Select this Type or Media
Type setting
ColorLife Photo Paper
Ink Jet Transparencies
EPSON Stylus Photo RX500
- 5
Печатать страницу