Crow SH-MAG-SHOCK-9F Руководство по эксплуатации

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Датчики безопасности Crow SH-MAG-SHOCK-9F. Crow SH-MAG-SHOCK-9F 3 страницы. Two way wireless magnetic door/window contact & shock detector

Печатать страницу

SH-MAG-SHOCK-8F/9F

TWO WAY WIRELESS

MAGNETIC DOOR/WINDOW CONTACT

& SHOCK DETECTOR

INSTRUCTION MANUAL

P/N 7101689_C

BATTERY INSERTION

Figure 3

Batteries can be replaced by the user

Battery type:

Lithium. 3V Type: CR123A Size: 2/3AA

PRODUCT FEATURES

The SH-MAG provide perimeter protection for premises with

early warning upon attempted intrusion.

SH-MAG & SHOCK device analyzes shocks while ignoring

background vibrations. It can be configured Over-The-Air and

feature a 5 year battery life.

• Freewave2™ Two Way ISM

•

GFSK with 5 frequencies & LBT

• Immunity to attenuation feature

• Powered by 1 Lithium batteries 3.0V Size CR123

• Contact Open/Close transmission

• Shock detection transmission

• Tamper Open/Close transmission

• Battery life up to 5 years

•

Operating Frequencies: 868MHz or 916MHz

• Event Transmission:

Alarm

Tamper Open/Close

Supervision

Battery status

• Bi-Color LED indications

• Up to 500m transmission range in open space

• Remotely configurable

DETECTOR MOUNTING

Figure 4

Place the Magnet unit near this marking

DETECTOR OPENING

Figure 1

Pull out the detector cover

Figure 5

Basic installation at 10mm between FW2-Mag and Magnet Unit.

Removal Distance

Approach Distance

Configurations

Axis

(mm)

Wood

260

Iron

CIRCUIT LAYOUT

Figure 2

Remove the batteries cover

LEARNING PROCESS

For pairing process, please refer to your control panel

instructions.

To pair your device with Shepherd™ panel, please proceed

as follows:

1. Enter in installing mode via the "Installer Webpage"

2. Go to "Zones" and select the zone # you want to learn

1. Add Zone -(Reminder: insert Link Type "ISM" , device's

ID, Device Type "Magnetic & vibration sensor".)

2. Set the detector configuration: supervision time, VIB

sensitivity, and save configuration.

3. Place a battery as instructed in Figure 3 and wait until

the Red / Green LED stops blinking.

4. The device should register to the Control Panel.

5. When registration process is successfully completed, the

Green LED will constantly light ON for 3 seconds and

then turn OFF.

6. If Green LED continues flashing more than 5 minutes

and stopped, please check MAG-SHOCK settings

details, remove battery and repeat steps 3,4,5.

7. If Led flashes green constantly , please check if device's

ID is correct or missing.