Epson Stylus Photo R380
Note: Do not open ink cartridge packages until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
1. Make sure the printer is turned on, the CD tray is not
inserted, and the front tray is in the paper (lower) position.
2. If an ink cartridge is expended, the LCD screen indicates
which cartridge(s) you need to replace. Press
If an ink cartridge is low, the LCD screen displays a message
when you print. Press
Setup
press
. Press u or d to select
OK
then press
.
OK
3. Open the printer cover, then open the cartridge cover.
Caution: Never attempt to open the cartridge cover while the
print head is moving; wait until the cartridges have moved to the
replacement position.
To avoid damaging the printer, never move the print head by
hand.
4. Squeeze the back tab of the used cartridge as you lift it
straight out. Dispose of it carefully. Don't take the cartridge
apart or try to refill it.
Warning: If ink gets on your hands, wash them thoroughly with
soap and water. If ink gets in your eyes, flush them immediately
with water. If discomfort or vision problems continue after a
thorough flushing, see a doctor immediately.
Note: If an ink cartridge is low, you may continue to use it until it
is expended.
5. Remove the new cartridge from the package.
Epson Stylus Photo R380
8 -
.
OK
, select
, then
Maintenance
,
Change Ink Cartridge
Caution: Do not touch the
green IC chip on the side of the
cartridge. This can damage the
ink cartridge.
Always install an ink cartridge
immediately after removing the
old cartridge. If the cartridge is
not installed promptly, the print
head may dry out and be
unable to print.
6. Remove the yellow tape from
the bottom of the ink
cartridge.
Caution: You must remove the yellow tape from the cartridge
before you install it; otherwise, print quality may decline or you
may not be able to print. If you have installed an ink cartridge
without removing the yellow tape, take the cartridge out of the
printer, remove the yellow tape, and then reinstall it.
Do not remove the transparent
seal from the bottom of the
cartridge; otherwise, the cartridge
may become unusable.
Do not remove or tear the label on
the cartridge; otherwise, ink will
leak.
7. Lower the new ink cartridge into the holder. Push down
gently until the cartridge clicks into place.
8. If you need to replace other ink cartridges, repeat steps 4
through 7 before continuing with step 9.
10/06
Печатать страницу