Acuity Brands Lighting 4BPMW LED Инструкции по установке - Страница 2

Просмотреть онлайн или скачать pdf Инструкции по установке для Блок управления Acuity Brands Lighting 4BPMW LED. Acuity Brands Lighting 4BPMW LED 5 страниц. 6"/5"/4" baffle led module

Печатать страницу
Prior to installing the fixture, disconnect ALL power supplies to the unit. This module may be installed in TYPE IC or NON-IC
installations. For TYPE NON-IC INSTALLATION ONLY: No insulation may be placed over the top of or within 3" (76mm) of the
fixture.
INSTALLATION INSTRUCTIONS FOR 6BPMW LED AND 5BPMW LED
Step 1: 6BPMW LED - Determine Mounting Method
A. Housing with torsion brackets (see Figure 1); use torsion springs to
install LED module.
Go to Step 2 – Grounding Wire
•
B. Housing without torsion brackets; use retention clips to install LED
module.
1.
Remove the springs (see Figure 2).
2.
Select retention clip position (Figure 3).
• Housing inside diameter 6.20" or less; use upper clip slots
(Figure 4). Insert clips at the upper three slots (Figure 6).
• Housing inside diameter 6.20" or more; use lower clip slots
(Figure 5). Insert clips at the lower three slots (Figure 6).
3.
Go to Step 2 – Grounding Wire
Figure 4
If the retention clips are in the bottom position (see Figure 4), make sure there are no obstructions that will interfere with the clips 1"
•
from the bottom of the recessed housing.
If the retention clips are in the top position (see Figure 5), make sure there are no obstructions that will interfere with the clips within 2-
•
1/4" from the bottom of the recessed housing
Step 1: 5BPMW LED - Determine Mounting Method
A. Housing with torsion brackets (see Figure 1); use torsion springs to install LED module.
Go to Step 2 – Grounding Wire
•
B. Housing without torsion brackets (see Figure 7); use retention
clips to install LED module.
1.
Remove top cap screws and discard the torsion spring
brackets.
2.
Insert three clips into upper slots.
3.
Go to Step 2 – Grounding Wire
Lithonia Downlighting
One Lithonia Way / Conyers, GA 30012
800-315-4935 / www.lithonia.com
INSTALLATION INSTRUCTIONS
6BPMW LED (6" Baffle LED Module); 5BPMW LED (5" Baffle LED Module)
4BPMW LED (4" Baffle LED Module)
Torsion springs
Figure 5
Top Cap Screws
Torsion
Bracket
Existing Housing
Torsion
brackets
Figure 2
Figure 6
Part No. CJ5201106 Rev. E
©20011 Acuity Brands Lighting, Inc., 12/11
Figure 1
Figure 3
Figure 7
Page 2 of 5