Epson TM-L90 series Руководство по производству - Страница 14

Печатать страницу

Epson TM-L90 series Руководство по производству

1. Automatic Paper Layout Setup

Confidential

3.11 Requirements for Black Mark Position I

The black mark positions on the paper to be manufactured must meet the requirements in the

figure below. (The ESC/POS commands expand the settable range, omitting the margin settings

or the limitation on use (NOTE 2 of Section 3.6).) The reflective rates of the black mark portions

(1) and label portions (2) must meet the combinations shown in the table below (the reflective

rate is measured using the back of the paper, the non-printing side):

• Black mark portions must be printed on the back of paper (non-printing side).

• The length of the black mark must cover the space between labels (backing paper

between labels) completely (overlapping labels by 0 ~ 1 mm).

Reflecting rate for black mark

portion (1)

Reflecting rate for label portion

(2)

Cutting

position

NOTE: Reflective rates are measured by the Macbeth PCM-II (Filter D) meter.

17%

90%

0 ~ 1

Preprintable area

Back (non-printing side)

TITLE

TM-L90

Roll Paper

Manufacturing Guide

16%

15%

85%

80%

(Dotted lines indicate the label

position.)

0 ~ 1

4 ~ 7.5

15 or more

(2)

(1)

SHEET

REVISION

14%

13%

Less

75%

70%

Paper feeding direction

[Units: mm]

NO.

SHEET