Epson EL 3S/33 Руководство по информации о продукте - Страница 7

Просмотреть онлайн или скачать pdf Руководство по информации о продукте для Настольный компьютер Epson EL 3S/33. Epson EL 3S/33 9 страниц. Product support bulletin(s)
Также для Epson EL 3S/33: Бюллетень поддержки продуктов (1 страниц)

Печатать страницу

If the computer has an Epson-supplied 80MB, 120MB, or

240MB hard disk drive, select a user-defined drive type and

enter the appropriate information from the table below using

the SETUP program.

Epson-supplied Hard Disk Drive Types

Actual formatted size may be slightly different then size on drive label.

Installation/Support Tips

Installing Diskette Drives

Make sure that the drive type has been correctly selected in

the SETUP program.

Installing Hard Disk Drives

It is recommended that a 16-bit, AT-type hard disk

controller be used if you are installing a drive that cannot

use the embedded IDE interface. If you install a non-IDE

hard disk drive and controller card, you need to disable

the built-in IDE hard disk drive interface by moving

jumpers J25 to position 2-3 and J22 to the Off position.

When installing a hard disk drive, see the hard disk drive

type tables on page 7 and use the SETUP program to

select the correct type number for the drive. You can

select a type number that matches the parameters for the

drive or a type number with parameters having lesser

values, as long as they do not exceed the maximum

capacity (in MB) of the drive. If there is no match for the

drive, you can select a user-defined drive type (48 or 49)

and enter the drive's exact parameters.

If you are going to install NetWare 286, version 2.2, do not

assign a user-defined disk drive type for your disk drive.

Assign the pre-defined hard disk drive type that most

closely matches the drive you are installing.

If you are installing an ESDI hard disk drive, make sure

you disable the built-in IDE hard disk drive interface by

moving jumpers J25 to position 2-3 and J22 to the Off

position. Also be sure to remove the hard disk drive

ribbon connector from the system board.

Software Problems

When installing a copy-protected software package, first

try the installation at high speed. If this does not work

properly, select low speed by pressing the Ctrl and Alt

keys and the - key on the numeric keypad

simultaneously. Try loading the program at low speed

and then switching to high speed, if possible.

When using a software package that uses a key disk as its

copy-protection method, try loading it at high speed. If

this does not work, load it at low speed.

Installing Option Cards

Although the EL 3S/33 will support most full-length option

cards, option cards with an I/F connector on the back may

not fit into the option slot.

Note that the EL 3S/33 system does not support older option

cards requiring -5 VDC.

COM Port Assignment

If you want to assign COM1 as COM3, you must set jumper

J10 to position 2-3. You also need to install a special driver

available from Epson technical support.

Using IBM 3270/PC 3270 Emulation

If you are using the IBM 3270/PC 3270 Emulation Entry

software, version 2.2, you may see only half the font when

you switch from a terminal emulation session to DOS Install

the patch program available from Epson technical support.

Information Reference List

Engineering Change Notices

None.

Technical Information Bulletins

None.

Product Support Bulletins

None.