Motorola HT600E Series Руководство - Страница 3

Просмотреть онлайн или скачать pdf Руководство для Двухстороннее радио Motorola HT600E Series. Motorola HT600E Series 3 страницы. Basic re-alignment of the following re-programming
Также для Motorola HT600E Series: Руководство (21 страниц)

Печатать страницу

On completion:

1. Remove the battery and test equipment.

2. Slacken the two larger screws in the battery adaptor plate and replace the

front cover.

3. Replace and tighten all screws – including the two slackened previously - and

check operation.

Re-alignment may be completed by radiating a signal into the Rx and out of the Tx

and adjusting the above trimmers for best performance. However this may not be

as accurate as re-aligning the set using correctly attached test equipment.

Tx deviation is set in software when re-programming each set.

Battery plate:

If the two screws securing the battery plate to the radio are not fully tightened, the

radio can operate intermittently, or not at all. Check they are both fully tightened

after re-assembling the case. If the fuse is found to be open circuit it can be replaced

with 5amp domestic fuse wire.

Fuse

Check

fully

tightened

Downloaded from: http://groups.yahoo.com/group/ht600e