Epson Endeavor 4DX2/50 Руководство по информации о продукте - Страница 6
Просмотреть онлайн или скачать pdf Руководство по информации о продукте для Настольный компьютер Epson Endeavor 4DX2/50. Epson Endeavor 4DX2/50 9 страниц. Product information guide
Печатать страницу
EPSON Endeavor 4SX/25, 4DX/33, and 4DX2/50
Jumper Settings
J5
J7
Adapter, CMOS, and PQFP jumper Settings
Jumper
Jumper
number
setting
Function
J5***
On
Supports CGA adapters
Off*
Supports monochrome, EGA, MCGA, and
VGA adapters
J6
1-2*
Enables the built-in VGA display adapter
2-3
Disables the built-in VGA display adapter so
you can use a display adapter on an option
card in the computer as the primary adapter
Returns CMOS RAM to the factory settings
J7***
On
Off'
Retains SETUP program settings
J6
1-2*
Reserved
J18
1-2*
Gate A20 reset (standard setting for windows)
2-3
Keyboard reset
J23**
1-2
Enables the WFP SX/25 processor
2-3
Disables the PQFP SX/25 processor
* Factory setting
**
Factory setting depends on type of processor on system board
** Two pin jumpers
l
Processor Jumper Settings
You need to change the processor jumper settings if you
install a new processor chip. The settings for J10, J11, and J12
correspond to the type of chip installed.
must
EPSON Endeavor-6
If the computer's microprocessor is a FQFP type, it is surface-
mounted on the main system board. To add an OverDrive
processor, install it in the empty OverDrive socket and
disable the original microprocessor by setting jumper J23 to
position 2-3. Also make sure J10, J11, and J12 are set correctly.
Processor Speed Jumper Settings
You need to change the processor speed jumper settings if
you replace a 25 MHz processor with a 33 MHz processor.
J13
J15
Processor Chips
If you have the 4SX/25 or 4DX/33 system, you can install an
Intel OverDrive processor on the main system board to
effectively double the internal clock speed of the computer's
microprocessor. Alternatively, for the 4SX/25, you can install
the 487SX/25 microprocessor with built-in math coprocessor.
OverDrive Processors
System
4SX/25
40X/33
SIMM Installation
The computer comes with 4MB of memory installed in a
SIMM socket. To increase the amount of memory in the
computer up to 32MB, you can install 36-bit, fast-page mode
SIMMs that operate at an access speed of 70ns or faster, with
a capacity of 1MB, 4MB, or 16MB.
The following table shows the possible SIMM configurations;
do not install memory in any other configuration. Make sure
that both SIMMs operate at the same speed.
SIMM Configurations
SIMM 0
4MB
4MB
1MB
4MB
16MB
16MB
1MB
16MB
4MB
16MB
Standard memory
l
4/1/93
OverDrive processor
ODP486-25
ODP486-33
Total memory
SIMM 1
4MB *
4MB
4MB
5MB
1MB
4MB
5MB
4MB
8MB
16MB
16MB
16MB
1MB
17MB
16MB
17MB
20MB
4MB
16MB
20MB
16MB
32MB