Dimac J06 Руководство по установке - Страница 5

Просмотреть онлайн или скачать pdf Руководство по установке для Промышленное оборудование Dimac J06. Dimac J06 6 страниц.

Печатать страницу

❖Adjusting Press cam signals

Feed signal adjusting

Set the feed start position to feed signal OFF position.

When you make the feed starts on 270°,

Set the ON angle of feed to 240°, and set the OFF angle to 270°

Need to set the ON of the feed signal to the

feed completed angles when using option

"Overrun-Function".

Release signal adjusting

Set the ON to the release start angle, and set

the OFF to the finish.

When the release angle is assumed to 200°from 200°,

you turn on the press cam signal in 110 degress,

and turn off in 200 degress.

The retention angles of the release ON must

be 25 degrees or more.

Need to adjust the signal of the release

start even if the release system is used a

time setting of timer or angles.

❖Release setting in the controller 【（＿Release Mode）】

【（＿Release Mode）】　The display is the back screen of 【 Feed Length 】.

The Release mode is supposed to display on the "Feed Length" after displaying digit of lowest of "Feed

Length"

Using "＋" or "-" switch, Set the release mode.

The Release mode are as follows, Release OFF, Synchronization press cam signal, Timer finish.

Display and contents

Feed Length　　（＿Release Mode ）

_ _ Sync

_ _ _ OFF

_ _ _ A01

～

_ _ _ A50

_ _ _ T01

～

_ _ _ T50

NOTE

Synchronization press cam signal

Invalid the release signal, Release off state.

Release angles setting. It can be input from 1°to 　50°.

the control calculates the release time from the setting SPM and the

anggles, the release will operate in the time range.

Input the release strat using the press cam signal.

Release timer setting. It can be input from 0.001sec to 0.05 sec.

Input time period, the release carry out.

Input the release strat using the press cam signal.

The release operation is delayed due to air cylinder.

The delay time will vary depending in the springs pressure.

Press cam signal

0°

270°

240°

180°

0°

270°

200°

180°

Contents

90°

60°

90°

110°