Epson Progression Руководство по информации о продукте - Страница 7

Просмотреть онлайн или скачать pdf Руководство по информации о продукте для Настольный компьютер Epson Progression. Epson Progression 8 страниц. Using with ms windows 3.x stylus 400/800+/color printer driver
Также для Epson Progression: Бюллетень поддержки продуктов (15 страниц), Бюллетень поддержки продуктов (17 страниц), Бюллетень поддержки продуктов (3 страниц)

Печатать страницу

Epson Progression Руководство по информации о продукте

Installation/Support Tips

Power

This computer has an automatic input voltage sensing power

supply (between 115V, for USA and Canadian use, and 230V,

for use in other countries). There is no manual switch.

Mouse and Keyboard

plug them into the proper ports. Although they are

physically identical, they are not interchangeable, and

damage may occur to the ports or the main board.

Installing Diskette Drives

you may need to set the drive select jumper to the second

position and attach the pass-through connector on the

floppy drive controller cable to the drive, not to the end

c o n n e c t o r .

drive type has been correctly selected in SETUP. Also

check that any necessary drivers have been installed

correctly.

Installing Hard Disk Drives

controller be used if you are installing a drive that cannot

use the embedded IDE interface. Installing a 16-bit

interface will override the embedded IDE port and disable

it, freeing the standard base I/O address and IRQ(s).

SETUP

drive type table for the drive type parameters (geometry)

which fit the drive you are installing. You can also select a

type with parameters having lesser values, as long as they

do not exceed the maximum capacity (in MB) of your

drive. If there is no match for your drive, enter the exect

parameters using the User Defined option.

Software Problems

try the installation at high speed. If this does not work

properly, try switching to low speed for theinstallation. If

you are still unable to load the program at high speed, try

loading at low speed and then switching to high speed.

installed. For the 486SX/25, high speed is 25 MHz; for the

486DX/33, high speed is 33 MHz; and for the 486DX2/66

card, high speed is 66 MHz. All systems simulate 8 MHz

at low speed.

copy-protection method, try loading it at high speed. If

this does not work, enable Auto Speed in SETUP.

Power-on Password

you set up. If you do, it will be necessary to disable it by

moving jumper JP6 on the main circuit board to position A.

Information Reference List

Engineering Change Notices

None.

Technical Information Bulletins

None.

Product Support Bulletins

None.