Epson ColorWorks C3500 Руководство по настройке - Страница 2
Просмотреть онлайн или скачать pdf Руководство по настройке для Изготовитель этикеток Epson ColorWorks C3500. Epson ColorWorks C3500 4 страницы.
Печатать страницу
Epson C3500
6. Installing Media
You must set the PC printer driver
badge specifications before the next steps.
a. For Fanfold Badge Stock, lift the back lid of
the printer (and if needed lift the blue lever to
adjust for the media with.)
page.
b. Making sure the orientation is correct.
timing mark facing down, leading first with arrows
facing towards the printer.
badge stock into the back of the printer until it
comes to a stop and then printer pulls it
through.
Do Not push the badge stock too hard.
Setup Video Guide:
Scan this QR code
with your phone
camera for video.
RENTAL EQUIPMENT
settings to your
See next
e.g., Black
Carefully feed the
SETUP GUIDE
a. For Roll Badge Stock, open the front
door by pulling the dark grey latch.
Now remove the "Paper Feed Guide" a
shown below.
(clear grey plastic
b. Lift the blue latch on the inside of
the printer (left side) and adjust the
width of the Roll Guide.
c. Insert the Roll to have it feed paper over
its top, not the bottom. Pull some badge
stock out and push the blue latch down to
lock it in place.
d. Close the front panel leaving a bit of paper
sticking out to begin auto calibration.
Contact our Support Team:
www.choose2rent.com/help
+1 (800) 622-6484 Ext. 3 (USA)
+49 40 226 360 - 590 (Europe)
piece)