Motorola Astro XTL 5000 Руководство по эксплуатации - Страница 28
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Радио Motorola Astro XTL 5000. Motorola Astro XTL 5000 38 страниц. Dual-radio w3 handheld control head system
Печатать страницу
5-2
5.2.2
Cables
This section describes the installation of the dual-radio system cables.
5.2.2.1 Dual-Radio Cable
The 3064426H01 cable connects the Primary and Auxiliary radios to the W3-style HHCH (via the
quick-disconnect connector). Attach the yellow radio connector end of the 3064426H01 cable to the
front left of the Primary radio (female connector, labeled "Control Unit"). Securely tighten the two
screws. Attach the red radio connector end of the cable to the front left of the Auxiliary radio (female
connector, labeled "Control Unit"). Securely tighten these two screws also. The quick-disconnect end
of the 3064426H01 cable will attach to the HHCH and is mounted in the operator's compartment.
This end of the cable also contains the connections for the speakers, the emergency foot switch, and
the ignition sense.
5.2.2.2 Power and Ground Cables
Route the red radio power cables from both radios to the vehicle's battery compartment, using
accepted industry methods and standards. It is important that both power leads are connected to the
battery, rather than using one power lead through the vehicle and splitting it to both radios. This is
because it is possible to have both mobile radios transmit at the same time (OTAR, data, etc.) and
the power cable for each radio is rated to handle the maximum transmit current of that radio only.
Be sure to grommet the firewall hole to protect the cable. Remove the 15-amp (P/N 6580283E06) or
20-amp (P/N 6580283E07) fuse from the fuseholder and connect the red lead of the radio power
cable to the positive battery terminal using the hardware provided as shown in
the black lead to a convenient solid chassis ground point. DO NOT connect the black lead directly to
the battery's negative terminal.
RADIO COMPARTMENT
CAUTION
A good chassis connection via the black primary
power cable is essential for radio operation and
to prevent damage to the radio and cable kit.
Connection to the vehicle frame is desirable.
PRIMARY
RADIO
REAR
CONNECTOR
RADIO
POWER CABLE
(BLK/GROUND)
AUXILIARY
RADIO
REAR
CONNECTOR
Figure 5-2. Cabling Interconnect Diagram for W3 Remote Mount
October 27, 2004
OPERATOR COMPARTMENT
DUAL
SPEAKER 1
RADIO
CABLE
IGNITION LEAD
GROMMET
(ORANGE)
Dual-Radio Installation: Trunk Units
HAND HELD
CONTROL HEAD
VEHICLE
IGNITION SWITCH
QUICK DISCONNECT
CONNECTOR
ON/ACC
SPEAKER 2
3A OR 4A
FUSE
RADIO POWER CABLE
(RED/HOT)
Figure
5-2.
Connect
VEHICLE BATTERY
COMPARTMENT
PART OF
VEHICLE
GROMMET
WIRING
(+)
(-)
15A OR 20A
FUSE
VEHICLE
BATTERY
MAEPF-27994-1-A
9964416H03-O