Motorola GP1280 Series Базовое руководство по обслуживанию - Страница 37
Просмотреть онлайн или скачать pdf Базовое руководство по обслуживанию для Радио Motorola GP1280 Series. Motorola GP1280 Series 46 страниц. Professional radio, power distribution and controller
Также для Motorola GP1280 Series: Информация о сервисе (32 страниц), Информация о сервисе (30 страниц), Информация о сервисе (30 страниц)
Печатать страницу
1.0
Introduction
The receiver and transmitter performance tests are contained in Tables 4-1 and 4-2 respectively.
Refer to Chapter 5 for the test equipment set up. Note that all test measurements are taken at 25°C.
2.0
Receiver Performance Tests
The receiver performance tests are described in Table 4-1 below.
Test Name
Reference
Mode: PWR MON
Frequency
Monitor: Frequency error
Input at RF In/Out
Rated Audio
Mode: GEN
Output level: 1.0mV RF
Mod: 1kHz tone at
3kHz deviation
Monitor: DVM: AC Volts
Distortion
As above, except to distor-
tion
Sensitivity
As above, except SINAD,
(SINAD)
lower the RF level for 12dB
SINAD.
Noise
RF level set to 1mV RF
Squelch
Threshold
(only radios
with conven-
tional sys-
As above, except change fre-
tem need to
quency to a conventional
be tested)
system. Raise RF level from
zero until radio unsquelches.
Table 4-1 Receiver Performance Checks
Communications
Analyzer
PERFORMANCE TESTING
Radio
Test Set
TEST MODE,
PTT to continu-
Test Channel
ous (during the
4 carrier
performance
squelch out-
check)
put at
antenna
TEST MODE
PTT to OFF
Test Channel
(centre), meter
4 carrier
selector to
squelch
Audio PA
As above
As above
As above
PTT to OFF
(centre)
As above
PTT to OFF
(centre), meter
selection to
Audio PA, spkr/
load to speaker
out of TEST
As above
MODE; select
a
conventional
system
Chapter 4
Comments
Frequency error to be
± 200Hz VHF
± 600Hz UHF
Set volume control to
3.16Vrms
Distortion 3.0%
Typical
RF input to be
0.25 µ V
Set volume control to
3.16Vrms
Unsquelch to occur at
<0.25 µ V.
Preferred SINAD =
9-10dB