10.Click the AirPort icon on the menu bar at the top of the
Macintosh desktop. You see the AirPort status menu:
11.Check to make sure AirPort is turned on.
12.Select the name of your AirPort network.
Note: If you don't need the other network ports, disable them by
deselecting their checkboxes. If more than one network port is
enabled, the projector software warns you to turn off AirPort when
you first connect the projector. Disregard this message.
Your AirPort network and base station names may be different. To
check or change your AirPort network name, start the AirPort
Admin utility, select your base station, and click
, then make any changes you want on the AirPort
Show All Settings
tab.
If you're connecting to your projector in static IP mode, deselect the
checkbox. Make sure your projector's
Distribute IP addresses
gateway address is identical to the base station's IP address, and the
first three segments of the projector's IP address are identical to the
first three segments of the base station's IP address.
Projecting Over a Network
Once you've started EasyMP and set up your projector and
computer in either Ad Hoc (Quick) mode or Access Point
(Advanced) mode, follow these steps to start NS Connection
and project over the network.
1. Make sure you've set up your projector.
2. Windows: Select
EMP NS Connection
menu.
Mac OS X: Double-click the
your Applications folder.
. Click
Configure
from the Start
icon in
EMP NS Connection
3. The first time you start NS Connection, you see this dialog
box. Choose Quick Connection Mode and click
4. If you see a message asking you to disable the firewall make
an exception for the projector and allow projection. You see
the screen below. (If you have previously started NS
Connection, this may be the first screen you see.)
Select projector
If the connection is working properly, you see your projector
listed. If you don't see your projector listed, see "Solving
Connection Problems" on page 18. If you have additional
Epson projectors on the network, they are also listed along
with their status.
5. Once the name of your projector appears, select it and click
. If more than one projector is listed, you can select
Connect
additional ones and connect to them (up to four) at the same
time.
If the selected projector is already being used by another
person, you can still connect to it (unless it is "locked");
doing so automatically disconnects the other user. If a
projector is locked, you won't be able to connect to it when
it is in use.
3/08
PowerLite 1810p/1815p
.
OK
PowerLite 1810p/1815p
17
-
Печатать страницу