Epson ChromaBlast 1.0 Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Программное обеспечение Epson ChromaBlast 1.0. Epson ChromaBlast 1.0 13 страниц. For epson stylus pro 4880
Также для Epson ChromaBlast 1.0: Руководство по началу работы (47 страниц)
Печатать страницу
EPSON PowerLite Home 10 Projector
Turning the Projector On and Off
Once you've connected the projector to your computer or other
equipment, follow these instructions to turn it on and display
an image:
1. Make sure the power is turned off for the projector and any
sources connected to it.
2. Remove the lens cover.
3. Connect one end of the power cord to the projector and plug
the other end into a grounded electrical outlet.
The P
light on the projector turns orange, indicating
Power
that the projector is receiving power, but is not yet turned
on.
Orange
Note: The projector will not respond to any buttons on the
control panel or remote control while the power light is
flashing orange.
4. If you are connecting to video equipment, turn it on now. (If
you are connecting to a computer, don't turn it on yet.)
5. Press the P
button on the remote control or the top
Power
of the projector to turn on the projector.
You hear a beep, the P
projector warms up, and the projection lamp comes on in
about 45 seconds.
6. If you are using a computer, turn it on now.
The projector automatically detects the video source and begins
projecting.
If you don't see a picture, make sure the P power light on the
projector is green and not flashing, and the lens cover is off.
Also, make sure your cable is connected to both the projector
and your video equipment, and the video equipment is on. If
you still don't see a picture, see the suggestions in the
Troubleshooting section on page 6.
4 - EPSON PowerLite Home 10 Projector
light flashes green as the
Power
Turning Off the Projector
When you're ready to shut down the projector, follow these
steps:
1. Turn off your video equipment first. (If you're connecting to
a computer, leave the computer on.)
2. Press the P
Power
control.
3. When you see the confirmation message, press the P
button again to turn the projector off. (If you don't want to
turn it off, press any other button or ignore the message. It
disappears in about 7 seconds.)
The lamp is turned off and the P
as the projector cools down. When the projector has cooled,
the P
light stays orange and the exhaust fan shuts
Power
off.
Note: If you want to turn the projector on again, wait until
the orange light stops flashing. Then press the P
button.
4. Unplug the power cord from the electrical outlet.
Caution: Never disconnect the power cord while the
P power light is green or flashing orange. You may damage
the projector.
5. Replace the lens cover and retract the projector's adjustable
feet.
6. Store the remote control in its holder on the back of the
projector. (Part of the remote control will stick out when it's
fully inserted.)
Adjusting the Image
1. To raise the picture, turn the projector's front feet.
7/03
button on the projector or remote
light flashes orange
Power
Power
Power