3Com SuperStack II Руководство пользователя - Страница 3

Просмотреть онлайн или скачать pdf Руководство пользователя для Сетевой маршрутизатор 3Com SuperStack II. 3Com SuperStack II 6 страниц. Switch matrix module
Также для 3Com SuperStack II: Руководство пользователя (4 страниц), Руководство пользователя (9 страниц), Руководство пользователя (2 страниц), Дополнительный лист (1 страниц), Важная информация (2 страниц)

Installing the Module

We recommend that you install the Matrix Module into the

unit that will be at the bottom of your stack.

1 Remove the blanking plate from the rear of the Switch. You

should store it carefully for future use.

2 Hold the Matrix Module so that the text on the front panel

reads correctly, and guide it into the slot ensuring it is

located in the rails. See Figure 1.

Ensure that the connector on the Matrix Module engages

with the board inside the Switch. Press the Module fully into

the Switch.

3 Tighten the two captive screws to secure the Matrix Module

into the unit.

Figure 1 Inserting the Matrix Module into the Switch

Cabling

With the Matrix Module installed, you can connect up to

four Switches in a stack. A typical configuration is shown in

Figure 2.

Figure 2 A typical stack of switches

You only need one Matrix Module for each stack.

The way in which units in the stack are numbered for man-

agement purposes is determined by the order of port con-

nections to the Matrix Module. The units are numbered 1 to

4 from the bottom unit up.