Dimplex BF8000ST Руководство по эксплуатации - Страница 14

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Крытый камин Dimplex BF8000ST. Dimplex BF8000ST 16 страниц. 26” self trimming fireplace
Также для Dimplex BF8000ST: Руководство пользователя (16 страниц), Руководство пользователя (17 страниц)

Печатать страницу

shock or damage to persons.

Remove the firebox from the mantel.

Lay unit on its back.

Remove the 12 Philips screws that fasten the bottom

cover to the rest of the firebox. There are: two (2)

screws on each side; two (2) screws on the back panel

(you may have to tip the bottom of the fireplace up

if it is laying on its back), four (4) screws in the front

directly under the control panel; and two (2) screws

on the bottom of the fireplace (Figure 8). The bottom

panel is now free to be removed.

Locate the Remote Control Receiver (Figure 20)

mounted underneath the log set support panel and

disconnect the six (6) wiring clips noting their original

locations.

Disconnect the three (3) wire leads from the 3-Position

Switch. (The wires are hard-wired to the Remote

Control Receiver) (Figure 20)

NOTE: A flat head screwdriver can be used to gently

pry between the end of the connectors and the switch to

release the wires.

Pull the Antenna wire through the bottom of the

chassis.

Locate the three (3) LED indicator lights from inside the

bottom assembly of the firebox. (Figure 18)

NOTE: Using a flathead screwdriver, gently push on the

rear edge of the plastic bushing surrounding each LED and

push each LED out from the front of the control panel.

Clear any silicon that may be present and firmly grasp

the sheathed ends of the wires leading to each LED

and remove the plastic bushing from each LED. Each

LED and paired wires can be fed back through the front

control panel and into the bottom assembly area.

The Remote Control Receiver is fastened to the

underside of the ember bed support by four (4)

mounting studs, one in each corner (Figure 20). Either

squeeze each mounting stud's clasp, using needle

nose pliers, to release, or use side cutters to cut and

remove each of the four corner mounting studs on the

board.

! NOTE: If mounting studs are cut, replacement

mounting studs will need to be inserted from underneath

ember bed. Follow steps 1 - 5 of Partially Reflective

Glass Replacement procedure on Page 9 to do this. It

is recommended to attempt to release the control board

without cutting mounting studs, although new mounting

studs are provided.

10.

Properly orient the replacement Remote Control

receiver and adhere to the control panel with the

supplied/existing mounting studs.

11.

Once the remote control receiver is mounted,

reconnect and reassemble the fireplace in reverse

order as described above.

LEDs (3)

Figure 20

3-Position Switch

3-Position

Switch

Wires (3)

All Hard-

wired Ends

Antenna

Wire

Remote

Control

Receiver

Mounting

Studs (4)