CROWN LINE FT-30MC Краткое руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Вентилятор CROWN LINE FT-30MC. CROWN LINE FT-30MC 5 страниц. 12” metal table fan
Печатать страницу
6 Base
Assembly
Your new fan has been shipped partially assembled to reduce
wastage of packaging material, paper cartons and weight. Follow
the instructions below to assemble it; the illustration opposite
shows how all the parts fit together.
• Remove the protective sleeve (if any) from the motor shaft.
• Remove the four rear guard retaining screws from the motor
housing.
• Attach the rear guard to the motor housing using the four
screws you just removed. Make sure the handle is at the top.
Tighten the screws securely using a Phillips head screwdriver.
• Place the fan blade over the motor shaft so that the blade
retaining screw sits behind the blade. Tighten the screw securely
against the flat part on the motor shaft.
• Remove the grille rim screw and nut from the front guard and
open the clips around the outside edge of the front grille, turning
them outwards.
• Hang the front grille by its hook over the top of the rear guard,
making sure the holes for the rim screw and nuts are aligned.
Bring the front guard down to meet the rear guard and push the
clips inwards until the front guard is fastened to the rear guard.
Finally fit the grille rim screw and nut through the holes in the
bottom edge of the guard and tighten with a screwdriver.
1 Front guard (grille)
2 Blade
3 Rear guard (grille)
4 Grille rim screw
5 Grille rim nut
6 Rear guard retaining screws (4)
7 Speed control dial
8 Oscillation knob
9 Motor
10 Power cord
11 Neck
12 Body
13 Base
14 Feet