Error messages (continued)
Message
Light
RELOAD PAPER
Paper Out light on
UNABLE TO PRINT
—
NOZZLE CHECK ERROR
—
COMMAND ERROR
—
MAINTENANCE REQ.
—
MAINTENANCE REQ
—
0100
SERVICE REQ.
All lights flashing
SERVICE REQ. 00000100
All lights flashing
Printing a Status Check
The status check shows the amount of ink remaining in each
cartridge, the page count, and the status of various printer
parts.
NOTE: The user can replace the ink cartridges and cutter blade. Other
parts need to be replaced by an authorized EPSON service technician.
Follow these steps to print the status check:
1. Load a sheet of letter-size paper in the printer. (You can
print on roll paper, but you will use more paper.)
2. Press the
button on the control panel until you
SelecType
see
TEST PRINT MENU
Explanation
Paper could not be reversed into
the printing position.
Image is too wide for the paper
loaded in the printer.
Paper is not fully ejected.
PAPER NOT CUT error was
cleared.
You tried to print while an error
condition was present or the ink
compartment cover was open.
The nozzle check pattern did not
print correctly.
You're using the wrong printer
driver.
Damaged data was sent to the
printer.
A printer part will need to be
replaced soon.
The waste ink system is almost
full.
An error has occurred.
The waste ink system is full.
on the display.
Response
Remove the paper. Reload it so that the bottom edge is straight
and aligned with the vertical row of holes at the paper exit.
Resize your image or load wider paper.
Cut the paper at the paper insertion slot, then reload paper.
Reload paper.
After 3 seconds the message disappears. Press the Pause button
to exit SelecType mode. If the message appears again, clear the
error before you print.
Press and hold the Cleaning button on the control panel for at
least 3 seconds to begin cleaning the print head.
Make sure you installed the correct driver for your printer:
Stylus Pro 10600DYE driver for Photographic Dye
Stylus Pro 106000CF driver for Archival ink
Stylus Pro 10600UC driver for UltraChrome ink
To clear the data, press the printer's Power button to turn the
printer off. Wait for about a minute, then turn the printer on again.
Note the error number and contact EPSON.
Call an authorized EPSON servicer to schedule replacement of
the waste ink system.
Note the error number, and turn the printer off and then on. If the
message remains, contact EPSON.
Contact EPSON to have the waste ink system replaced.
3. Press the
button until your see
Item
.
CHECK=PRINT
4. Press the
button. The status check sheet prints.
Enter
The amount of ink left or the component life is indicated as
follows:
= full (or full life remaining)
E*****F
= 3/4 full (or 3/4 life remaining)
E**** F
= 1/2 full (or 1/2 life remaining)
E***
F
= 1/4 full (or 1/4 life remaining)
E**
F
= nearly empty (or service life near end)
E*
F
= empty (or service life ended)
E
F
5. Press the
SelecType
9/02
EPSON Stylus Pro 10600
STATUS
button to exit the Test Print menu.
EPSON Stylus Pro 10600 - 9
Печатать страницу