Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine Руководство по сборке и настройке - Страница 9

Просмотреть онлайн или скачать pdf Руководство по сборке и настройке для Программное обеспечение Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine. Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine 14 страниц. Product support bulletin
Также для Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine: Брошюра и технические характеристики (8 страниц), Технический паспорт (8 страниц), Руководство по быстрой установке (34 страниц), Информация о продукте (17 страниц), Краткая справка (10 страниц), Технические характеристики (4 страниц), Бюллетень поддержки продуктов (44 страниц)

Печатать страницу
Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine Руководство по сборке и настройке
6. Holding the ink cartridge with arrow mark on
the left side and pointing to the rear of the
printer, and insert it into the slot. Be sure to
match the colors of the seal of compartment
and the cartridge you are replacing.
7. Close the ink cartridge clamp backwards.
Make sure the corresponding Ink Out light
goes off. Repeat step 5 to 6 for the other five
color ink cartridges.
8. Close the ink compartment cover.
After installing all six ink cartridges, the
printer begins charging the ink delivery
system and the Pause light flashes (for about
7 minutes). When the ink delivery system is
charged, the Pause light stops flashing.
c
Caution:
Never do the following while the Pause light
is flashing; otherwise damage may occur:
Turn off the printer.
Open the front cover.
Open the ink compartment cover.
Move the paper lever to the released
position.
Unplug the power cord.

Loading Roll Paper

Note:
The instruction here is for the 2-inch roll paper spindle
(L). However, the procedure for 3-inch roll paper
spindle (M) is the same.
1. Slide the movable flange off the end of the
spindle.
2. Place the roll paper on a flat surface so that it
unwinds in the direction shown. Slide the roll
paper onto the spindle and fully onto the fixed
flange.
3. Slide the movable flange back onto the spindle
until it fixes into place in the end of the roll
paper.
4. Open the roll paper cover. Holding the
spindle, fit the right end of the spindle into the
mounting bracket inside the printer.
Note:
The spindle and mounting brackets are
color-coded. Mount the spindle into the
mounting bracket that is the same color as the
end of the spindle.
When you mount two roll paper spindles on
your printer, mount the 3-inch type on the
upper side brackets and the 2-inch type on the
lower brackets.
7