Philips AZ102S Руководство пользователя - Страница 15

Печатать страницу

1. Power Supply

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING:

Problem

– Possible cause

• Remedy

No sound /power

– Volume not adjusted

• Adjust the VOLUME

– Power cord not securely connected

• Connect the AC power cord properly

– Batteries dead/ incorrectly inserted

• Insert (fresh) batteries correctly

– CD contains non-audio files

• Press ∞ , § once or more to skip to a CD audio

track, instead of the data file.

Display does not function properly / No

reaction to operation of any of the

controls

– Electrostatic discharge

• Switch off and unplug the set. Reconnect after a

few seconds

Do not open the set as there is a risk of electric shock. Under no

circumstances should you try to repair the set yourself, as this will

invalidate the guarantee.

--, Er or 01 indication

– No CD inserted

• Insert a CD

– CD badly scratched or dirty

• Replace/ clean CD, see Maintenance

– Laser lens steamed up

• Wait until lens has cleared

– CD-R/CD-RW is blank or not finalized

• Use a finalized CD-R/CD-RW or suitable CD

Audio disc only

Note:

Make sure the CD is not encoded with copy-

right protection technologies, as some do not

conform to the Compact Disc standard.

The CD skips tracks

– CD damaged or dirty

• Replace or clean CD

– Program/shuffle is active

• Quit program/shuffle mode

Note: A CD badly scratch or dirty may result in

improper operation.