Epson V11H255020 - PowerLite 83c XGA LCD Projector Руководство по информации о продукте - Страница 12

Просмотреть онлайн или скачать pdf Руководство по информации о продукте для Программное обеспечение Epson V11H255020 - PowerLite 83c XGA LCD Projector. Epson V11H255020 - PowerLite 83c XGA LCD Projector 16 страниц. Warranty statement
Также для Epson V11H255020 - PowerLite 83c XGA LCD Projector: Руководство пользователя (42 страниц), Руководство по эксплуатации (36 страниц), Руководство по эксплуатации (47 страниц), Руководство по быстрой настройке (7 страниц), Функциональное руководство (5 страниц), Бюллетень поддержки продуктов (5 страниц), Список деталей (1 страниц), Декларация о соответствии (4 страниц)

Печатать страницу

Epson V11H255020 - PowerLite 83c XGA LCD Projector Руководство по информации о продукте

PowerLite 822p/83c Projector

You can remove the air filter to clean both sides.

If the dirt is difficult to remove or if the filter is torn, replace

it. Contact your dealer or call Epson at (800) 463-7766 to

obtain a new one (part number V13H134A13).

3. If you need to clean or replace the filter, slide it out, as

shown.

4. Align the new filter carefully and slide it in until it clicks

into place.

Note:

Air filters contain polycarbonate, ABS resin, and polyurethane

foam. Dispose of used air filters according to local regulations.

PowerLite 822p/83c Projector

Replacing the Lamp

The projection lamp typically lasts for about 3000 hours of use

(in high brightness mode) or 4000 hours (in low brightness

Vent

mode). It is time to replace the lamp when:

❏ The projected image gets darker or starts to deteriorate.

❏ The

❏ The message

when the lamp comes on. To maintain projector brightness

Air filter

and image quality, replace the lamp as soon as possible.

Note:

You can check to see how many hours the lamp has been used

through the Info menu.

Contact your dealer or call Epson at (800) 463-7766 for a

replacement lamp. Request part number V13H010L42.

Warning:

Let the lamp cool before replacing it. If the lamp breaks, handle the

shards carefully to avoid injury.

Follow these steps to replace the lamp:

1. Press the P

When you hear the projector beep twice, unplug the power

cord.

2. If the projector has been on, allow it to cool down for at

least an hour (or until the lamp is cool).

3. Use the screwdriver included with the replacement lamp (or

a #2 Phillips-head screwdriver) to loosen the screw holding

the lamp cover on top of the projector.

4. Slide the cover out, then lift it off.

3/08

lamp light is flashing orange.

appears on the screen

Replace the Lamp

button twice to turn off the projector.

Power