Croydex AP400522 Инструкции по монтажу

Просмотреть онлайн или скачать pdf Инструкции по монтажу для Внутренняя отделка Croydex AP400522. Croydex AP400522 2 страницы. Straight grab 'n' grip bar

Печатать страницу

Fittings instructions for :-

AP400522 - 12"/30cm Straight Grab 'N' Grip Bar

AP400622 - 18"/46cm Straight Grab 'N' Grip Bar

AP400722 - 24"/60cm Straight Grab 'N' Grip Bar

Thank you for purchasing this Croydex product. Please follow the fixing and care

instructions to ensure your grab bar is fitted safely and retains its high quality finish.

Tools Required

Pencil

Drill

Masonry drill bit appropriate to fixings used

Ceramic drill bit (optional) appropriate to fixings used

Spirit Level

Cross head screwdriver

Please ensure that suitable fixings are purchased that are compatible with wall

construction materials.

KEEP DIY TOOLS OUT OF THE REACH OF CHILDREN

Safety and Care Advice

1. Always take care when using a drill, particularly in the bathroom. Always check

for hidden cables and pipework before drilling and take extreme care if there is

any water in the working area.

2. Always use a residual current circuit breaker (RCCB) when using mains powered

tools and take extreme care if there is any water in the working area.

3. Always wear suitable eye protection when drilling.

4. If the product is to be fitted on a ceramic tiled wall, a ceramic drill bit should be

used. Always ensure that the drill hole passes through the central tiled area

rather than through the grouted area. To prevent damage to the tile, mask the

area around the hole with tape before drilling.

5. It is recommended that two people fit this product to ensure that it is fitted safely.

Product Location

Grab and support bars are only as strong as the wall to which they are fixed and the

fixings that are used.

For different wall types you will need to ensure that you are using the correct type of

fixing for the material of the wall.

The addition of backboards on the outside of the wall or appropriate strengthening of

internal structures may be required to provide adequate wall strength.

NOTE: If the wall is made of lightweight thermal blocks, aerated hollow brickwork

or prefabricated partitions even the most appropriate fixings may not be able to

withstand the loads which can be suddenly applied to grab bars.

S&H 012 R02