Croydex Beaulieu Series Руководство - Страница 4

Просмотреть онлайн или скачать pdf Руководство для Сантехническая продукция Croydex Beaulieu Series. Croydex Beaulieu Series 7 страниц. Vanity unit, mirror and light

Печатать страницу

Light Module Installation (optional)

1. Align the two pilot holes at the top of the mirror with the corresponding holes located on the light

module.

2. Thread the lighting cable through the channel on the rear of the mirror prior to securing the light module

in position.

3. IMPORTANT: The lighting cable must be threaded through the channel on the rear of mirror and

located into the recess at the rear of the mirror.

4. Using the screws provided, secure the light modules onto the mirror using the a philips screwdriver.

DO NOT OVERTIGHTEN

Mirror Installation

Marked Screw Position

Place the bottom edge of the

Hang 'N' Lock bracket onto the

reference line and using a pencil,

mark the screw hole positions in each

cam recess. Remove the Hang 'N' Lock

bracket from the wall surface prior to

drilling.

CONNECTING TO THE MAINS SUPPLY

Ensure that the switched electrical mains supply to which the light unit is to be connected is

turned off.

Connect the flexible mains supply cable on the light unit to the switched lighting circuit

ensuring that the Live (Brown) conductor is connected to the switched Live on and the Neutral

(Blue) conductor is connected to the Neutral on the domestic electrical mains supply. Note:

Connection of the product to the domestic electrical mains supply must only be carried out by

a Building Regulations Part P certified electrician or must be checked by your Local Authority

Building Control Department.

Top edge of Mirror

'A'

Bottom edge of Hang 'N' Lock bracket

Drill the marked holes to a depth of 45mm.

Insert the wall plugs level with the surface

of the wall. (Note: if you are fitting the

product to a tiled surface, insert the wall

plugs below the surface of the tile to avoid

cracking, the tile) Insert 2 x screws (Either

countersink or standard screws can be

used) through the Hang 'N' Lock cams and

loosely secure the Hang 'N' Lock bracket

to the wall.

Assemble the Hang 'N' Lock bracket sections

making sure all parts are slotted together tightly.

Place the Hang 'N' Lock bracket onto the

hanging baton at the back of the mirror and

measure the dimension 'A' – See fig.1.

Determine the desired location above the Vanity

Unit and mark a point at the top edge of the

mirror on the wall surface. Using dimension 'A'

draw a horizontal reference line below the top

mark to determine the position of the bottom

edge of the Hang 'N' Lock bracket.

With the Hang 'N' Lock bracket loosely

attached to the wall, adjust for height

and level by rotating the cams with

a flat head screwdriver aligning the

bottom edge of the HNL bracket with

the reference line, then fully tighten the

mounting screws using a philips

screwdriver, to securely fix the bracket

into position. Adjust for level if required.

Hang the mirror onto the Hang 'N' Lock

bracket, to complete the installation.

CAB 100 R01