Dimplex CXLS12N Руководство по установке - Страница 3

Просмотреть онлайн или скачать pdf Руководство по установке для Нагреватель Dimplex CXLS12N. Dimplex CXLS12N 8 страниц. Ultra-slim automatic storage and convector heaters
Также для Dimplex CXLS12N: Инструкция по эксплуатации (5 страниц), Руководство по установке (8 страниц), Инструкция по эксплуатации (5 страниц), Руководство по эксплуатации (11 страниц)

7. Fitting directly on the ﬂ oor. If the ﬂ oor is carpeted then the carpet

may be slit and underlay cut away to allow the feet to rest ﬁ rmly on the

ﬂ oor. Carpet gripper must be locally removed so that the feet may rest in

a level position.

9. Remove wall ﬁ xing bracket from heater by removing the screws and

spacer bushes at each end.

11. Solid Brick/High Density Block Walls. (See step 12 if walls are of

low density block) These must be drilled and plugged with the No. 10 size

plastic inserts provided. The correct size of drill (8mm) should be used and

the hole should be drilled to a depth of 15mm greater than the length of the

plastic insert, so that the ﬁ xing is made below the plaster layer.

8. Having decided on the method of standing the heater on the ﬂ oor the

position of the wall bracket should be marked on the wall.

10. Four ﬁ xing positions must be chosen for the 24N, three

for the 18N and two for the 12N . Mark the positions for

the ﬁ xing holes - two at the extreme ends and the others

spaced evenly between them. Remove the bracket from

the wall, drill the holes in the positions marked, and insert

suitable ﬁ xings detailed in Steps 11 and 12. Secure the

wall bracket to the wall.

12. Low Density Block Walls. A specialised ﬁ xing, such as the Uniﬁ x LB70.

should be employed following closely the manufacture's instructions.

Panelled Internal Walls. Here it is best to locate the studding and use

No.10 size woodscrews. Where it is not possible to locate the studding

use type M5 Rawlplug INTERSETS on securely fastened plasterboard

panelling. For other wall panel materials the wall panel manufacturer should

be consulted for details of suitable wall ﬁ xing devices.