CRU Dataport DataPort 525 Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Шкаф CRU Dataport DataPort 525. CRU Dataport DataPort 525 13 страниц. Usb 2.0 and firewire enclosure

Печатать страницу

NSTALLING THE

ARD

ISK

1. Remove the four screws in the corners of the back of the

enclosure.

2. Slide the covers up and away from the back of the enclosure.

3. On the top is a metal cover. On the end there are two indents;

grip them with your fingers and pull the metal cover off towards

the rear of the enclosure (see Diagram 5).

4. Remove the front bezel by depressing the clips on the front of

the enclosure. Slide the front bezel off the front of the enclo-

sure.

5. Plug the data cable and the power cable into the hard disk

drive. Slide the drive into the enclosure. Guide the power

cables underneath the connectors on the power switch. Fasten

the drive to the bottom of the enclosure with the provided

screws (see Diagram 6).

6. When sliding the hard drive into the enclosure make sure the

cable is pulled upwards or push the cable down into the enclo-

sure. If the cable is pulled upward, fold the data cable over top

of the hard disk drive. Place cable so it will not interfere with

drive insertion.

7. Slide the covers back on and snap them into place. Re-install

the four screws in the back of the enclosure (see Diagram 7).

8. Connect the USB/FireWire cable from the computer's

FireWire or USB port to the enclosure.

9. Plug the provided power cable into the back of the enclosure.

WWW.CRUINC.COM • (800) 260-9800

(DP350)

RIVE

Diagram 5

Diagram 6

Diagram 7