3Com OfficeConnect 3CRWE454A72 Руководство по установке

Просмотреть онлайн или скачать pdf Руководство по установке для Беспроводная точка доступа 3Com OfficeConnect 3CRWE454A72. 3Com OfficeConnect 3CRWE454A72 2 страницы. Configuring a wireless distribution system (wds) with the 3com officeconnect wireless 11a/b/g access point
Также для 3Com OfficeConnect 3CRWE454A72: Технический обзор (6 страниц)

Печатать страницу

Installation Guide

OfficeConnect

Wireless 11a/b/g Access Point

(3CRWE454A72)

3Com Corporation, Corporate Headquarters, 350 Campus Drive, Marlborough, MA 01752-3064

are registered trademarks of 3Com Corporation.

Microsoft, MS-DOS and Windows are registered trademarks of Micorsoft Corporation.

All other company and product names may be trademarks of their respective companies.

Part number: DIA0045-4AAA01 Published: December 2003

About Your Access Point (front)

WLAN

LAN Status

Alert

Power

11g 11a

Alert LED orange

Indicates a number of different conditions, as described below.

Off – The Access Point is operating normally.

Flashing quickly – Indicates one of the following conditions:

– the Access Point has just been started up and is running a self-test

routine

– the administrator has invoked the Reset to Factory Defaults command

– the system software is in the process of being upgraded

In each of these cases, wait until the Access Point has completed the

current operation and the alert LED is Off.

Flashing slowly – The Access Point has completed the Reset to Factory

Defaults process, and is waiting for you to reset the unit. To do this, release

the reset button and allow the unit to restart. The Access Point will then

enter the start-up sequence and resume normal operation.

About Your Access Point (back)

Ethernet

Wireless Antennae

The antennae on the product should be placed in a 'V' position.

Power Adapter socket

Only use the power adapter that is supplied with this Access Point. Do not

use any other adapter.

Power Adapter OK LED green

Indicates that the power adapter is supplying power to the Gateway. If the

LED is off, there may be a problem with the power adapter or adapter

cable.

OfficeConnect Wireless 11a / b / g Access Point

Continuously on – A fault has been detected with your Access Point during

the start-up process. Refer to the main User Guide.

Power LED green

Indicates that the Access Point is powered on.

Wireless LAN (WLAN) Status LED green

If the LEDs are on it indicates that wireless networking is enabled. If the LED

is flashing, the link is OK and data is being transmitted or received. If the

LED is off, the Wireless LAN has been disabled in the Access Point, or there

is a problem (refer to the User Guide).

RESET

Ethernet port

Using suitable RJ45 cable, you can connect your Access Point to a

computer, or to any other piece of equipment that has an Ethernet

connection (for example, a hub or a switch). This port has an automatic

MDI/MDIX feature, which means either straight-through or a crossover

cable can be used.

Reset Button

If you want to reset your Access Point to factory default settings, and

cannot access the web management interface (for example, due to a lost

password), then you may use this button. Refer to the User Guide for

further details.

3CRWE454A72

LAN Status LED green (100Mbps link) / yellow (10Mbps link)

If the LED is on, the link between the port and the next piece of network

equipment is OK. If the LED is flashing, the link is OK and data is being

transmitted or received. If the LED is off, nothing is connected, or the

connected device is switched off, or there is a problem with the connection

(refer to the User Guide). The port will automatically adjust to the correct

speed and duplex.