Dimplex DS5804 Руководство пользователя - Страница 7

Просмотреть онлайн или скачать pdf Руководство пользователя для Плита Dimplex DS5804. Dimplex DS5804 14 страниц. Electric
Также для Dimplex DS5804: Практическое руководство пользователя (11 страниц), Руководство по эксплуатации (13 страниц), Руководство пользователя (16 страниц)

NOTE: A 15 Amp, 120 Volt circuit is required. A dedicated circuit is

preferred but not essential in all cases. A dedicated circuit will be

required if, after installation, the circuit breaker trips or fuse blows

on a regular basis when the heater is operating. Additional

appliances on the same circuit may exceed the current rating of the

circuit breaker.

WARNING: Ensure the power cord is not installed so that it is

pinched or against a sharp edge and ensure that the power cord

is stored or secured to avoid tripping or snagging to reduce the risk

of fire, electric shock or injury to persons.

Construction and electrical outlet wiring must comply with local

building codes and other applicable regulations to reduce the risk of

fire, electric shock and injury to persons.

Do not attempt to wire your own new outlets or circuits. To reduce

the risk of fire, electric shock or injury to persons, always use a

licensed electrician.

Stove Installation

Make sure the units Main On/Off switch is switched Off (refer to

operating instruction section).

Plug the unit into a 15 Amp/120 Volt outlet. If the cord does not

reach, you may use an extension cord rated for a minimum of 1875

Watts.

To access the controls go to the back of

the Stove (figure 2).

A. Three Position On/Off Switch

The switch has two On positions marked with

"-" and "=". The "-" position is for manual

operation. In this position, the built-in remote

control is bypassed.

The "=" position is for operating the unit with the

provided remote control. When in "=" position the unit is operated with

the ON and OFF buttons of the remote control.

Figure 2