Dimplex RHAPSODY Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Плита Dimplex RHAPSODY. Dimplex RHAPSODY 9 страниц. Electric stove

RESETTING THE TEMPERATURE CUTOFF SWITCH

Should the heater overheat, an automatic cut out will turn the heater off and it will not come

back on without being reset. It can be reset by switching the MAIN ON/OFF SWITCH to OFF

and waiting 5 minutes before switching the unit back on.

CAUTION

If you need to continuously reset the heater, unplug the unit and call Dimplex North America

Limited at 1-800-668-6663.

MAINTENANCE

WARNING

Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire,

electric shock or damage to persons.

LIGHT BULB REPLACEMENT

Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental

burning of skin.

Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity

and detail of the log exterior disappears. There are two bulbs under the log set which generate

the flames and embers.

TOOL REQUIREMENTS

Slot screw driver

HELPFUL HINTS

It is a good idea to replace all light bulbs at one time if they are close to the end of their rated

life. Group replacement will reduce the number of times you need to open the unit to replace

light bulbs.

UPPER LIGHT BULB REQUIREMENTS

Quantity of 1 –15 watt candelabra E12 small base 120 volt. DO NOT EXCEED 15 WATTS

UPPER BULB REPLACEMENT

1. Remove the stove pipe kit (if equipped).

2. Remove the 2 screws at the upper corners of the back panel. Lift the back end of the

top to clear the brackets and pull back. Lift top carefully, and place to the side of the

stove. Caution should be taken as the top mounting brackets may scratch the finish.

3. Remove the burned bulb by pushing in and turning counter-clockwise.

4. Replace the upper light bulb.

5. Reassemble in the reverse order as above.

LOWER LIGHT BULB REQUIREMENTS

Quantity of 3 – 35 watt Halogen Quartz lamps, 120 volt, G9 base. DO NOT EXCEED 35

WATTS PER BULB

LOWER BULB REPLACEMENT

1. Remove the stove pipe kit (if equipped).

2. Gently place stove on its back on a flat surface.

3. Remove the heater cover retaining screws located on the bottom of the stove and lower

heater and light assembly out onto the floor.

4. Remove the burnt out bulb(s) by pulling straight out of socket. If bulbs are difficult to

remove form socket move the bulb from side to side while pulling being careful not to

damage the light socket.

5. Replace the lower light bulbs.

6. Reassemble in the reverse order as above.