CrustBuster DrillMaster Справочное руководство - Страница 3
Просмотреть онлайн или скачать pdf Справочное руководство для Сельскохозяйственное оборудование CrustBuster DrillMaster. CrustBuster DrillMaster 9 страниц. Grain drill section controller
Печатать страницуInstallation (cont)
Electrical Installation
This section explains how to connect your DrillMaster
to a12-volt power source, and how to connect your oil
bypass valves or dump valves.
NOTE: The DrillMaster must be connected to a 12-volt
DC negative ground electrical system.
POWER/BATTERY CONNECTION
Locate the power cable for the DrillMaster and route to the
battery. When routing cable to console, avoid areas where
the cable may be subjected to abrasion or excessive heat.
Attach the BLUE wire (ground) to a screw or bolt on the
equipment frame. See Illustration 3. Be sure there is a
good metal-to-metal contact. Connect the ORANGE wire
to the positive battery terminal. Connect the power to the
DrillMaster console by plugging the 2-pin W/P tower on
the power cable into the 2-pin W/P shroud of the display
console.
Installation (cont)
Attaching the Speed Sensor
The DrillMaster uses an Astro 5 GPS Speed Sensor.
The speed sensor always connects to the 3-pin
M/P connector with the yellow tie (on the back of
DrillMaster).
Speed calibration entered into the controller
must be 0.189.
CrustBuster
DrillMaster Quick Start Guide
346-001150
ON/OFF SWITCH CONNECTION
The DrillMaster system uses P/N 14360 power
switch to turn the system on. If the P/N 14360 power
switch is used, simply mount the switch bracket as
shown on page 10, and plug the connector into the
mating cable from the console.
Pg 3
Revised 4/2/2010