Crutchfield 000PERIG Руководство по установке - Страница 7
Просмотреть онлайн или скачать pdf Руководство по установке для Автомобильный приемник Crutchfield 000PERIG. Crutchfield 000PERIG 7 страниц. Peripherals installation
Печатать страницу000PERIG
Panel Removal (Continued)
Pillar Trimpanel removal
Remove seat belt if present. Remove screw covers, screws and plastic re-
taining clips, if present. Pry up edges of panel to remove (Figures 4 & 5).
Kickpanel removal
Look for screws and pry-out retaining clips to remove. Pry out edges of
panel to release and remove (Figure 6).
Routing wire behind dash
Route wire behind dash and secure with plastic wire ties. Be sure that
wire does not interfere with any moving parts to ensure safe operation of
vehicle.
Routing wire for components and power connections
Determine desired locations for each component. Use the most direct
route for wires. Remove panels necessary to route and conceal wires.
Test system before reinstalling panels.
Tech Tips
• Changer connection may be found at tuner amp module for select
Ford vehicles, or in the trunk area at the factory changer location.
The factory changer cable plug is usually found underneath the trunk
carpet. Volkswagen Jetta and select Volkswagen vehicles may have a
dummy plug over the changer cable, which must be removed before
connection is made.
•Most USA SPEC remote mount changers will not mount in factory
location. Velcro strips may be used to keep changer in place instead
of drilling screw holes.
•RF modulated changers can use the factory stereo power wires.
•GM or Chevrolet vehicles may have a factory mini antenna plug. An
antenna adapter will be required when installing an RF modulated
changer.
®
Copyright 2005 Crutchfield Corporation
FIGURE 4
Lower Pillar Trimpanel
FIGURE 6
Kickpanel
FIGURE 5
Upper Pillar Trimpanel
!
SAFETY CHECK
✔ Check that wires do not interfere with safe vehicle
operation.
✔ Make sure seats and seat belts are secured to
manufacturers' specifications if removed.
7