Crux RVCVW-73L Краткое руководство по эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Автомобильная электроника Crux RVCVW-73L. Crux RVCVW-73L 2 страницы.

INSTALLING THE CAMERA AND INTERFACE

1. Open the trunk and find a location that will allow you to access the license plate area.

2. Remove the left side license plate light, disconnect and remove the light bulb from the

assembly.

3. Insert the light bulb into the new license plate light camera housing.

4. Fish the camera cable through the license plate light and inside the cabin. You may need

to drill a pass through hole if you cannot find one.

5. Prepare to wire the Power Down Circuit provided in the kit. Please see diagram on the

next page for wiring instructions.

6. Place the new license plate light camera housing into the empty slot and snap it in place.

7. Run the camera extension cable along the side of the vehicle towards the radio.

8. Remove the radio to gain access to the factory connectors.

9. Make the power and video connections

Please follow these steps to code the radio for reverse camera option:

1. Close all the doors.

2. Put the key to the ON position. (Do not start the car)

3. Connect the OBD II coder to the vehicle's OBD II port.

4. Look at the GREEN LED inside the OBD II coder. LED should be solid GREEN.

5. Disconnect the OBD II coder.

6. Turn the key OFF and remove key.

7. Open and close the driver door, then lock the car.

8. Wait for approximately 2 minutes.

9. Start the car, put into reverse gear and confirm if reverse imager is on the screen.

10. Keep the OBD II encoder stored in the vehicle in case the radio would need to be recoded.

To decode the radio, repeat steps above.

The RVCVW-73L module has 2 LEDs on the side of the Molex connector that confirms its

functionality as follows:

Flashing LEDs = Coding vehicle

Solid GREEN = Activated

Solid RED = Deactivated

Solid RED and GREEN = Error

VOLKSWAGEN

2012 – 2015

Beetle

2 / 2

rev.020521