Aeon Labs Garage Door Controller Gen5 Руководство пользователя - Страница 8
Просмотреть онлайн или скачать pdf Руководство пользователя для Контроллер Aeon Labs Garage Door Controller Gen5. Aeon Labs Garage Door Controller Gen5 11 страниц.
Печатать страницу17.09.2018
Press and hold the Latch Button, and then push the Sensor into the mounting plate.
Test Garage Door Controller.
After completing all installation steps, you may need to test your Garage Door Controller to see if it has been
successfully installed. You can implement this via short pressing the Switch Button on the Garage Door Controller.
When you press the Switch Button, you will see the alarm LED blink and ring the alarm sound. After about 5 seconds,
the garage door will move to a full open or closed position. If you press the Switch Button again, the garage door will
immediately stop moving. If not, please check or repeat the steps above.
Pair Tilt Sensor to your Garage Door Controller.
By default, the Tilt Sensor should already be paired to your Garage Door Controller, if you find that they are not paired
together and the tilt sensor position is not changing the status of your Garage Door Controller over your interface,
please follow the steps below.
1. Press and hold the main GDC button (located on the front of the unit) for 5 seconds then release.
2. Make sure that it entered sensor pairing mode, look at the back of the GDC and refer to the LED, it should be
blinking slowly at a rate of once per second.
3. Tap the Tilt Sensor tamper switch once.
4. The LED on the main GDC unit should stop blinking which should indicate that the pair was successful.
Calibration Steps via Parameter 34.
If you have confirmed the installation is successful, you need to calibrate the Sensor once. For detailed calibration
steps, please refer to the "Configuration Parameter 34" as below: Parameter 34[1 byte dec] can be configured through
your gateway or controller.
https://aeotec.freshdesk.com/support/solutions/articles/6000053811-garage-door-controller-gen-5-user-guide-
Garage Door Controller Gen5 user guide. : Aeotec by Aeon Labs
8/11