Aeon Labs Nano Shutter Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Контроллер Aeon Labs Nano Shutter. Aeon Labs Nano Shutter 10 страниц.

After your Nano Shutter is installed and powered on, you are now able to manually control the Nano Shutter to open and

close your the motor connected directly via pressing your Nano Shutters Action Button. It is now time to add your Nano

Shutter to the Z-Wave network. To set your Z-Wave gateway/controller into pairing mode, please refer to the respective

section within your controller instruction manual.

1. Set your Z-Wave controller into pairing mode.

2. Press the Action Button on the Nano Shutter once or toggle the external manual switch once, the green LED (non-

secure indication) will blink to indicate the Nano Shutter is entering into pairing mode.

3. If the Nano Shutter has been successfully added to your Z-Wave network, its RGB LED will be solid. If the pairing was

unsuccessful, the red LED will be on for 2 seconds and then remain a colorful gradient. Repeat the instructions above from

step 1.

With your Nano Shutter now working as a part of your smart home, you'll be able to configure it from your home control

software/phone application. Please refer to your software or gateway user guide for further instructions on configuring

Nano Shutter to your needs.

The colour of RGB LED will change according to the output load power level:

Version

Removing Nano Shutter from a Z-Wave network.

Your Nano Shutter can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's

main controller. To set your Z-Wave controller/gateway into removal mode, please refer to the respective section within

your controller instruction manual.

1. Set your Z-Wave controller into removal mode.

2. Press the Action Button on the Nano Shutter 6x times within 2 seconds.

3. if the Nano Shutter has been successfully removed from your Z-Wave network, its RGB LED will remain colourful

gradient. If the removal was unsuccessful, the RGB LED will still be solid (following the state of the output load), repeat the

instructions above from step 1.

Advanced functions.

Changing mode on the External Switch/Button Control.

LED indication

Green

Yellow

Red

Green

Yellow

Red

Green

Yellow

Red

Output (A)

[0A, 7.5A)

[7.5A, 13.5A)

[13.5A, 15.5A)

[0A, 5A)

[5A, 9A)

[9A, 10.5A)

[0A, 5A)

[5A, 9A)

[9A, 10.5A)