Pioneer DEH-P3110 Руководство - Страница 6

Просмотреть онлайн или скачать pdf Руководство для Автомобильный приемник Pioneer DEH-P3110. Pioneer DEH-P3110 36 страниц. High power cd player with fm/mw/lw tuner

Печатать страницу

&RQQHFWLQJ WKH 8QLWV

• This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a

recreational vehicle, truck or bus, check the battery voltage.

• To avoid shorts in the electrical system, be sure to disconnect the

installation.

• Refer to the owner's manual for details on connecting the power amp and other units, then make

connections correctly.

• Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape

around them where they lie against metal parts.

• Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and

seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of

the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body.

• Don't pass the yellow lead through a hole into the engine compartment to connect to the battery. This

will damage the lead insulation and cause a very dangerous short.

• Do not shorten any leads. If you do, the protection circuit may fail to work when it should.

• Never feed power to other equipment by cutting the insulation of the power supply lead of the unit

and tapping into the lead. The current capacity of the lead will be exceeded, causing overheating.

• When replacing fuse, be sure to use only fuse of the rating prescribed on this unit.

• Since a unique BPTL circuit is employed, never wire so the speaker leads are directly grounded or

the left and right

speaker leads are common.

• The black lead is ground. Please ground this lead separately from the ground of high-current products

such as power amps.

If you ground the products together and the ground becomes detached, there is a risk of damage to the

products or fire.

• Speakers connected to this unit must be high-power types with minimum rating of 45 W and

impedance of 4 to 8 ohms. Connecting speakers with output and/or impedance values other than those

noted here may result in the speakers catching fire, emitting smoke, or becoming damaged.

• When this product's source is switched ON, a control signal is output through the blue/white lead.

Connect to an external power amp's system remote control or the car's Auto-antenna relay control

terminal. (Max. 300 mA 12 V DC.) If the car features a glass antenna, connect to the antenna booster

power supply terminal.

battery cable before beginning