AeonAir RDH60EB Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Осушитель AeonAir RDH60EB. AeonAir RDH60EB 15 страниц.

Печатать страницу

AeonAir RDH60EB Руководство пользователя

OPERATING INSTRUCTIONS

INSTALLING PVC DRAIN HOSE

When the water tank is full and/or incorrectly positioned inside the cabinet, the water full red light

turns on and remains on until such time that the tank is emptied and/or correctly re-positioned.

This condition will result in the immediate shut down of the dehumidifying system (both compressor

and fan motor operations are terminated). This is a safety feature. When the water tank is emptied

and/or correctly re-positioned, the dehumidiﬁer will resume operation automatically.

NOTE: It may take several minutes before operating conditions resume.

CONTINUOUS DRAIN (garden hose not included)

The function of continuous drain can be performed using the

following steps:

1. To save having to periodically empty the water tank, this unit

can be conﬁgured for continuous drain. You can use a garden

hose to connect to the continuous drain connector.

2. Unscrew and remove the drain cover at the rear of the unit (Fig.

A).

3. Remove the soft rubber stopper and place it in the water tank

for safe keeping (Fig. B).

4. Ensure the rubber seal ring is properly seated in the end of the

hose as shown in Fig. C.

5. Connect the garden hose to the drain port (Fig. D).

6. Tighten the garden hose in a clockwise direction onto the rear

of the unit (Fig. D).

7. Place the bucket in its original location (Fig. E).

Fig. A

Fig. B

Drain cover

Garden hose

(not included)

Fig. C

Rubber seal ring

Garden hose

(not included)

Fig. D

Garden hose

(not included)

Fig. E

Soft rubber

Bucket

stopper

Drain cover

CARE AND MAINTENANCE

CLEANING

CAUTION: Before attempting to clean and/or service this unit, always disconnect the power supply

cord from the electrical supply outlet.

1) DO NOT use gasoline, benzene, paint thinner, or any other chemicals to clean this unit, as

these substances will damage/deform both plastic components and luster ﬁnish.

2) Never attempt to clean the unit by pouring water directly over any of the surface areas, as this

will cause deterioration of electrical components and wiring insulation.

3) Use only a mild dish washing detergent, lukewarm water, and a soft cloth to wipe the exterior

surface of the unit and dry thoroughly.

STORAGE

When the dehumidiﬁer is not being used for long time periods, please follow these instructions:

1) Disconnect the power cord from the power supply.

2) Empty the water tank and wipe (dry) thoroughly.

3) Clean air ﬁlter thoroughly.

4) Re-package the unit in the original carton.

5) Store the unit upright in a dry location.

TROUBLESHOOTING

Occasionally, you may encounter some problems that are of a minor nature and a service call

may not be necessary. Use this troubleshooting guide to identify possible problems you may be

experiencing.

PROBLEM

1) Unit will not operate.

2) Dehumidifying capacity

(moisture removal) low.

3) Relative Humidity setting not

reached after long period of operation.

POSSIBLE CAUSE

• Check power cord connection.

• Check electrical outlet for blown fuse.

• Check if water tank is full (if yes, empty).

• Check water tank is properly installed.

• Ambient (room) temperature too low (below 41°F).

• Poor air flow circulation/obstruction of front grille.

• Air ﬁlter is dirty and/or blocked.

• Relative humidity in surrounding environment very low.

• Check all doors and windows are closed.

• Area/room is too large for the capacity of the dehumidifer.