Pioneer X-HX700 Инструкция по эксплуатации - Страница 10
Просмотреть онлайн или скачать pdf Инструкция по эксплуатации для Автомобильный приемник Pioneer X-HX700. Pioneer X-HX700 36 страниц. Cd/receiver system
Печатать страницу
Connecting System Components
2
Set up antenna
1
Assemble the AM loop antenna.
2
Connect the AM loop antenna.
Shift the tab to open a terminal, insert a wire
from the antenna cord, then set the tab back
to close the terminal.
After closing the terminals, pull gently on
each wire to make sure that it is securely
connected.
* This ground terminal is used for noise reduction. It
is not a safety-related ground connection.
Connect the AM loop
antenna's two-wire cord
to the CD/receiver's AM
antenna terminal.
Either wire can be
connected to the
terminal marked as the
ground terminal (H)*.
Antenna setup location
Set up the AM loop antenna on a flat surface and shift
the antenna around to find the direction which provides
the best AM (MW/LW) reception.
If the AM reception is poor in every direction, try setting
the antenna farther away from the CD/receiver.
Wall-mounted setup
Use two screws or push-pins to mount the
antenna on a wall.
Direction of FM antenna
The FM antenna can be left hanging from the CD/
receiver.
If the FM (UKW) reception is poor, extend the antenna
straight out and then change its angle to find the location
with the best reception. Use a fastener such as adhesive
tape to fasten the antenna to a wall or other vertical
surface.