Pioneer XC-P410T Руководство по эксплуатации - Страница 28

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Автомобильный приемник Pioneer XC-P410T. Pioneer XC-P410T 40 страниц.

Печатать страницу

1. Table of Contents

ie,

REVERSE MODE

DOLBY NR

=»

EOE

DECK

REC PAUSE

DISPLAY

aera

RECORDING

Recording on tape

Use the normal! tape or chrome tape.

(eran!

@ Material can be recorded on Deck !I only. Recording is not

possible on Deck {.

Load the tape for recording into Deck Hl.

@ Check to see that the accidental erasure prevention tab

has not been broken off.

@ Wind the tape forward past the leader to the start of the

magnetic coated portion.

Set REVERSE MODE.

pets

To record on one side of a tape.

DD, CD: To record on both sides of a tape

(From forward to reverse direction only).

Set the DOLBY NR switch to the desired

position.

@ A tape recorded using the DOLBY NR system must be

played back using the same system.

Select the program source to be recorded

using the function buttons on the

receiver.

5 Press REC PAUSE ( @ 11).

The deck enters record-standby mode.

Press PLAY (> or <)

to start recording.

@ The recording level is adjusted automatically

@ Except for U.K. models, microphone mixing sound can

be recorded. (See page 31.)

Play the program source to be recorded.

To stop recording:

Press STOP a.

To stop recording temporarily:

Press REC PAUSE (@ #f). To resume recording, press PLAY

(> oF <4).

@To display elapsed recording time:

Each time DISPLAY is pressed, the display switches between

current time and elapsed recording time.

NOTES:

The function cannot be switched during recording.

During recording, you can operate the SOUND

FIELD

CONTROL buttons but the resulting sound is not recorded.

AUTOMATIC TAPE SELECTOR FUNCTION

This unit (Deck | and Deck I!) is equipped with an automatic

tape selector function which utilizes the sensor holes on the

tape cassette to determine the type of tape being used, in

order to set the deck to match the tape recording bias and

equalization.

Sensor holes