Pioneer X-HM50-K Руководство по эксплуатации - Страница 17
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Приемник Pioneer X-HM50-K. Pioneer X-HM50-K 28 страниц. Cd receiver system
Печатать страницу
Listening to the FM radio
STANDBY/ON
STANDBY/ON
INPUT
PHONES
AUDIO IN
INPUT
n
Tuning
1
Press the STANDBY/ON button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to
select the "FM".
3
Press the TUNING (
control to tune in to the desired station.
• Manual tuning:
Press the TUNING (
to tune in to the desired station.
• Auto tuning:
When the TUNING (
for more than 0.5 seconds, scanning will start
automatically and the tuner will stop at the first
receivable broadcast station.
Notes
• When radio interference occurs, auto scan tuning
may stop automatically at that point.
• Auto scan tuning will skip weak signal stations.
• To stop the auto tuning, press the
button again.
• When an RDS (Radio Data System) station is tuned
in, the frequency will be displayed first, and then the
RDS indicator will light up. Finally, the station name
will appear.
To receive an FM stereo transmission:
• Press the
TUNER (BAND)
mode and "
" indicator will be displayed. "
ST
" " will appear when an FM broadcast is in stereo.
• If the FM reception is weak, press the
button to extinguish the "
changes to monaural, and the sound becomes
clearer.
VOLUME
TIMER
USB
X-HM50
or
) button on the remote
or
) button repeatedly
or
) button is pressed
TUNING (
button to select stereo
TUNER (BAND)
ST
" indicator. The reception
n
Memorising a station
You can store 40 FM stations in memory and recall
them at the push of a button. (Preset tuning)
1
Perform steps 1 - 3 in "Tuning".
2
Press the MEMORY button.
3
Within 30 seconds, press the PRESET (
button to select the preset channel number.
Store the stations in memory, in order, starting with
preset channel 1.
4
Within 30 seconds, press the MEMORY button to
store that station in memory.
If the "
MEMORY
disappear before the station is memorised, repeat
the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change
a preset station.
When a new station is stored in the memory, the
station previously memorised for that preset channel
number will be erased.
Note
The backup function protects the memorised stations
for a few hours should there be a power failure or the
AC power lead become disconnected.
n
To recall a memorised station
Press the
PRESET
seconds to select the desired station.
n
To scan the preset stations
The stations saved in the memory can be scanned
automatically. (Preset memory scan)
1
Press the PRESET ( or
or
)
seconds.
The preset number will flash and the programmed
stations will be tuned in sequentially, for 5 seconds
each.
2
Press the PRESET (
desired station is located.
" and
n
To erase entire preset memory
1
Press the STANDBY/ON button to enter the stand-
by mode.
2
Whilst pressing down the
STANDBY/ON button until "Tuner Clear" appears.
17
" and preset number indicators
(
or
) button for less than 0.5
) button for more than 0.5
or
) button again when the
button, press the
STANDBY/ON
or
)