Pioneer VSX-D7025 Руководство по эксплуатации - Страница 31
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Стереоприемник Pioneer VSX-D7025. Pioneer VSX-D7025 44 страницы.
Печатать страницу
REMOTE CONTROL OPERATION
LOADING BATTERIES
1. Open the battery compartment cover on the rear of the remote
control unit. The cover should open easily if you slide it in the
direction of the arrow while pressing on it with your thumb.
2. Take out the two supplied batteries (IEC LR6/AM-3), and insert
them into the battery compartment
in accordance
with the
indications in the compartment.
3. Press the RESET button.
4. Close the cover of the battery compartment.
RESET button
Cover
Incorrect use of batteries may lead to leakage or rupture.
Always be sure to follow these guidelines:
A.
Always insert batteries into the battery compartment correctly matching
the positive (+) and negative (—) polarities, as indicated inside the
compartment.
B.
Never mix new and used batteries.
c.
Batteries of the same size may have different voltages, depending on
their type. Do not mix different types of batteries.
REMOTE CONTROL RANGE
When operating the remote control unit, point the front of the unit at
the front panel of the receiver. The remote control unit may be used
within a range of about 7 meters (23 feet) from the remote sensor,
within angles of up to about 30 degrees.
Performance of the remote control unit is adversely affected in the
presence of strong fluorescent light. Keep such lights away, especially
from the sensor window.
Battery Replacement
When the batteries have run out, the CONTROL MODE buttons will not
light properly. Be sure to replace the batteries as soon as possible.
Remove the old batteries only if they can be replaced by new ones
immediately.
Load
batteries
by following
the
instructions
in the
"LOADING
BATTERIES" section.
Also be sure to always use the specified batteries (size "AA" (IEC LR6/
AN-3) alkaline batteries).
NOTE:
When no batteries are inserted, the programmed memory contents will
be erased after about 30 minutes.
When you want to clear the Programmed memory, refer to page 39.
The memory cannot be cleared simply by removing the batteries.
fe)
7m (23 feet)
OUTLINE OF BUTTON LAYOUT
© The buttons on the lower half of the rernote control command receiver
functions.
© Buttons on the upper half are used to operate other components.
¢ The remote control unit can ''learn'' the commands of other remote
control units.
© There are 12 kinds of preset signals for operation of VCR 1, VCR 2,
and TV. Select and use one of them.
¢ Amaximum of seven commands can be programmed into the MULTI
COMMAND
button,
enabling
transmission
of a sequence
of
commands at the push of a button.
LEARN button
(Pages 36, 37)
| EDIT button (Page 37)
MULTI COMMAND
i
Epo
i
tl
ti
button (Page 39)
Ooootd
OOOW
CONTROL MODE
O@
3
Operation buttons
buttons —
(OXo)
(Pages 33 — 36)
(Pages 33-36)
eo os ES
These buttons can be
:
[me
fas]
rogrammed with
BODE CEEGK button
Ed
shen
of other
-
{Page 36)
=
Receiver control
buttons (Page 32)
HB} | OO
3
CHS
(OG;
DEE
remote control units.
(Pages 36, 37)
31
<ARB1421>