Pioneer ND-G500 - Amplifier Инструкции - Страница 2

Просмотреть онлайн или скачать pdf Инструкции для Усилитель Pioneer ND-G500 - Amplifier. Pioneer ND-G500 - Amplifier 4 страницы. 4-channel gateway amplifier
Также для Pioneer ND-G500 - Amplifier: Руководство пользователя (44 страниц), Руководство пользователя (7 страниц), Руководство по эксплуатации (26 страниц)

Печатать страницу

In case of trouble

When the unit does not operate properly,

contact your dealer or the nearest autho-

rized PIONEER Service Station.

CAUTION

• Never replace the fuse with one of greater value

or rating than the original fuse. Use of an

improper fuse could result in overheating and

smoke and could cause damage to the product

and injury including burns.

WARNING

• Do not touch the amplifier with wet hands.

Otherwise you may get an electric shock. Also,

do not touch the amplifier when it is wet.

• For traffic safety and to maintain safe driving

conditions, keep the volume low enough so that

you can still hear normal traffic sound.

• Check the connections of the power supply and

speakers if the amplifier fuse blows. Detect the

cause and solve the problem, then replace the

fuse with another one of the same size and rating.

• To prevent malfunction of the amplifier and

speakers, the protective circuit will cut the power

supply to the amplifier (sound will stop) when an

abnormal condition occurs. In such a case, switch

the power to the system OFF and check the

connection of the power supply and speakers.

Detect the cause and solve the problem.

• Contact the dealer if you cannot detect the cause.

• To prevent an electric shock or short-circuit

during connection and installation, be sure to

disconnect the negative (–) terminal of the battery

beforehand.

• DO NOT allow amplifier to come into contact

with liquids due to, for example, the location

where the amplifier is installed. Electrical shock

could result. Also, amplifier and speaker damage,

smoke, and overheating could result from contact

with liquids. In addition, the amplifier surface

and the surface of any attached speakers could

become hot to the touch and minor burns could

result.

Connecting the Unit

CAUTION

• Disconnect the negative (–) terminal of the

battery to avoid the risk of short-circuit and

damage to the unit.

• Do not route wires where they will get hot, for

example where the heater will blow over them. If

the insulation heats up, it may become damaged,

resulting in a short-circuit through the vehicle

body.

• Make sure that wires will not interfere with

moving parts of the vehicle, such as the gearshift,

handbrake or seat sliding mechanism.

• Do not shorten any wires. Otherwise the

protection circuit may fail to work when it

should.

• Never feed power to other equipment by cutting

the insulation of the power supply wire to tap

from the wire. The current capacity of the wire

will be exceeded, causing overheating.

• Never replace the fuse with one of greater value

or rating than the original fuse. Use of an

improper fuse could result in overheating and

smoke and could cause damage to the product

and injury including burns.

CAUTION

To prevent damage and/or injury

• This unit is for vehicles with a 12-volt battery and

negative grounding. Before installing it in a

recreational vehicle, truck or bus, check the

battery voltage.

• If the car stereo is kept on for a long time while

the engine is at rest or idling, the battery may go

dead. Turn the car stereo off when the engine is at

rest or idling.