Pioneer PRS-D4200F - Premier Amplifier Руководство пользователя - Страница 11
Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель Pioneer PRS-D4200F - Premier Amplifier. Pioneer PRS-D4200F - Premier Amplifier 20 страниц. Bridgeable four-channel power amplifier
Также для Pioneer PRS-D4200F - Premier Amplifier: Руководство пользователя (50 страниц), Руководство по эксплуатации (38 страниц)
Печатать страницу
Interior of
the vehicle
Engine
compartment
FUSe(40A)X2/
Drill a 13 mm
Insert the O-ring rubber
hole into the
grommet into the vehicle
vehicle body.
body.
Positive (+)
tenninal
oL
1. Pass the battery wire from the
engine compartment to the interior
of the vehicle.
• After making all other connections to the
amplifier, connect the battery wire tenninal
of the amplifier to the positive
(+)
tenninal of
the battery.
2. Connect the wires to the terminal.
• Fix the wires securely with the tenninal
screws.
• Do not connect a cord having an exposed core
wire to the power tenninals of this amplifier
(Power tenninal, GND tenninal, System remote
control tenninal). Disconnection or breakage of
the core wire can cause a fire or short-circuit.
• Since the wire will become loose over time, it
must be periodically inspected and tightened as
necessary.
• Do not solder or bind the ends of the twisted
wires.
• Fasten while making sure to not to clamp the
insulating sheath of the wire.
• Use the supplied hexagonal wrench to tighten and
loosen the tenninal screw of the amplifier.
Securely fasten the wire with the tenninal screw.
However, since excessively tightening
the
tenni-
nal screw of the System remote control has the
risk of damaging the wire, be careful not to tight-
en excessively by observing the status of the wire
when tightening.
Connecting the Power Terminal
Solderless Terminal Connections
• We recommend that you use the special red bat-
tery and ground wire [RD-228], which is sold
separately. Connect the battery wire directly to
the car battery positive tenninal (+) and the
ground wire to the car body.
• Recommended wires size (AWG: American Wire
Gauge) is as follows. The battery wire and the
ground wire must be same size.
• Use a 10 AWG to 20 AWG wire for the system
remote control wire.
Battery Wire and Ground Wire Size
less than
less than
less than
4.5 m
7.2m
11.4 m
(14 f1. 9 in.) (23 f1. 7 in.) (37 f1. 5 in.)
8AWG
6AWG
4AWG
System remote
Tenninal screws
control tenninal
~~~
GND tenninal
powertenninal~~ ~
'l:t~~und
wire
Battery
wir~"",
System remote
control wire
A
WARNING
Failure to securely fasten the battery wire to the ter-
minal using the tenninal screws could cause the ter-
minal area to overheat and could result in damage
and injury including minor bums.