Ariston CIS LI 460 A Инструкция по установке и использованию - Страница 16

Просмотреть онлайн или скачать pdf Инструкция по установке и использованию для Посудомоечная машина Ariston CIS LI 460 A. Ariston CIS LI 460 A 24 страницы.

Печатать страницу

After performing all the operations

described in the previous para-

graphs, turn the water tap on com-

pletely, open the appliance door and

press ON-OFF button "A": indica-

tor light "B" comes on. Your appli-

ance is now on and awaiting in-

structions.

Select the wash cycle by pressing

button "P". Each time this button

is pressed, one of the indicator

lights "M" will come on in sequence,

select the wash cycle you deem

most suitable for the type of dishes

to wash (take a look at page 16,

where you will find the wash cycle

table). Close the appliance door and

after a few seconds, you will hear

a short beep: the wash cycle has

begun.

But if you have chosen the wrong

cycle, not to worry! You can modify

the wash cycle in progress, if it has

only just started. Open the appli-

ance door carefully to avoid any

hot water splashes, then keep but-

ton "P" pressed for approximately

5 seconds, until you hear 3 short

beeps. Indicator light "M" will come

off and at this point, all the settings

will have been cancelled. You are

now free to re-set the correct wash

cycle.

Well, it happens to everyone. Inter-

rupt the wash cycle by opening the

appliance door with the utmost

care, as usual, then insert the dish

you had forgotten. When you shut

the appliance door, the cycle will

start up from where you interrupted

it.

ARISTON DISHWASHER - Instructions for installation and use

The end of the wash cycle is indi-

cated by a double beep and the

flashing of the wash cycle indica-

tor light "M".

Warning!

Open the dishwasher door,

turn off by pressing button "A",

unplug the appliance from the

electricity socket to cut off the

power supply; the power sup-

ply cable should consequently

be easily accessible.

Turn off the water tap.

Wait a few minutes before unload-

ing the dishes: they are very hot!

If you wait a little while, they dry

better thanks to the steam.

Empty the lower rack first.

The wash cycle stops and then

restarts when the electricity

comes back on or when you close

the door. Everything is under

control!

When you have loaded the dishes,

you can choose when to start your

dishwasher before setting the wash

cycle desired.

Press button "C" to delay the start

of the wash cycle by 2, 4 or 6 hours.

Each time you press it, you will

hear a short beep and indicator light

"D" corresponding to the selected

delay will come on.

Now you can select the desired

wash cycle.

Close the appliance door and, after

you hear the beep, the countdown

to the delayed start will begin.

Once this time is up, indicator light

"D" will stop flashing and the wash

cycle will begin.

If you change your mind and you

wish to set a different delay, just

open the appliance door, press

button "C" and repeat the selection.

If on the other hand you want to

cancel the delay set and you wish

to start the wash cycle

immediately, press the button in

sequence until indicator light "D"

comes off.

Once you close the appliance door,

the wash cycle set previously will

begin.