Ariston LFP 5P31 WLT X Руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Посудомоечная машина Ariston LFP 5P31 WLT X. Ariston LFP 5P31 WLT X 45 страниц.

Печатать страницу

1. Open the dispenser B by pressing and pulling up the tab on the lid.

2. Carefully introduce the rinse aid as far as the maximum (110 ml) re-

ference notch of the filling space A - avoid spilling it. If this happens,

clean the spill immediately with a dry cloth.

3. Press the lid down until you hear a click to close it.

4. Confirm operation by pressing „OK" button.

NEVER pour the rinse aid directly into the tub.

Setting rinse aid level

(not necessary when using tablets/capsules)

The rinse aid dosage can be adjusted to the detergent used. The lower

the setting, the less rinse aid is dispensed. The factory setting is for (5)

level.

To change, follow instructions in section "SETTINGS / MENU".

7. Open tap operation

OPEN TAP

OPERATION

OPEN THE

OK = DONE

WATER TAP

OK = DONE

Check water tap is open. If closed, open it then confirm by pressing

„OK" button.

ADDING A DETERGENT

Usage of detergent not designed for dishwashers may cause

malfunction or damage to the appliance.

To achieve the best washing and drying results, the combined use of

detergent, rinse aid liquid and refined salt is required.

We recommend using detergents that do not contain phosphates or

chlorine, as these products are harmful to the environment.

Good washing results also depend on the correct amount of deter-

gent being used.

Exceeding the stated amount does not result in a more effective wash

and increases environmental pollution.

The amount can be adjusted to the soil level. In the case of normally

soiled items, use approximately either 35g (powder detergent) or

35ml (liquid detergent) and additional tea spoon of detergent directly

inside the tub. If tablets are used, one tablet will be enough.

If the crockery is only lightly soiled or if it has been rinsed with water

before being placed in the dishwasher, reduce the amount of deter-

gent used accordingly (minimum 25 g/ml) e.g. skip the powder/gel

putted inside the tub.

8. First cycle operation

FIRST CYCLE

OPERATION

REMEMBER TO RUN THE

OK = EXIT

INTENSIVE CYCLE

OK = EXIT

WITH EMPTY BASKETS

OK = EXIT

TO COMPLETE

OK = EXIT

THE FIRST SET UP

OK = EXIT

After this process the appliance is ready for normal use.

To open the detergent dispenser,

press button C. Introduce the deter-

gent into the dry dispenser D only.

Place the amount of detergent for

pre-washing directly inside the tub.

1. When measuring out the deter-

gent refer to the mentioned ear-

lier information to add the proper

quantity. Inside the dispenser D

there are indications to help the

detergent dosing.

2. Remove detergent residues from the edges of the dispenser and

close the cover until it clicks.

3. Close the lid of the detergent dispenser by pulling it up until the

closing device is secured in place.

The detergent dispenser automatically opens up at the right time

according to the program.

If you are using a All-in-one detergents, we recommend that you add

salt in any case, especially if the water is hard or very hard (follow the

instructions given on the packaging).

Before normal use of appliance it is

recommended to run Intensive cyc-

le first, to calibrate the appliance.

Insert a detergent into dispenser

chamber D (see below), then press

„OK" button.

Intensive cycle will be selected

automaticly. Press „START/PAUSE"

button.

This first cycle can be up to

20 minutes longer as a result of the

automatic calibration process.