Dinex CARLISLE Turbo-Temp DX1011208 Руководство по эксплуатации и техническому обслуживанию - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Зарядное устройство Dinex CARLISLE Turbo-Temp DX1011208. Dinex CARLISLE Turbo-Temp DX1011208 8 страниц.
Печатать страницуCheck:
Possible internal electronics fault. Unplug, wait 5 seconds,
and replug unit. If error persists, call Dinex service.
Message: Error! Check incoming voltage! If problem persists, Call
Dinex Service (888) 673-4639. 8
Condition: Line voltage measured to be out of range.
Check:
Major line voltage sags (severe brown out) or internal
electronics fault. Have maintenance verify line voltage.
Unplug, wait 5 seconds, and replug unit. If error persists,
call Dinex service.
Message: Critical Error! Time corrupted. Call Dinex Service (888)
673-4639. 9
Condition: Internal system clock time incorrect.
Check:
System clock backup battery dead, system clock electronics
fault, or electronic noise spike. Cycle POWER button.
Unplug, wait 5 seconds, and replug unit. If error persists,
call Dinex service.
Message: Critical Error! RFID failure. Call Dinex Service (888) 673-
4639. 15
Condition: RFID reader-to-host communications failure
Check:
RFID reader fault, internal power supply electronics fault,
CPU electronics fault, bad internal interconnect. Call Dinex
service.
Message: Critical Error! Electronics platform fault. Call Dinex
Service (888) 673-4639. 16
Condition: CPU memory corrupt.
Check:
Internal CPU fault or electrical noise spike. Cycle power. If
error persists, call Dinex service.
Message: Reheat later. (Clears when base is removed).
Condition: 1) Insufficient base cooling time or 2) Base time stamp has
corrupted information – but the unit automatically repaired
it.
Check:
Set base aside for reuse after one and one-quarter hour.
MAINTENANCE
Turbo•Temp CHARGER CLEANING INSTRUCTIONS
1. Unplug the charger before cleaning. Do not submerge the charger in
water. Do not splash or pour water onto the charger's control panel
or into intake/outlet vents. Possible shock hazard may result and the
charger may be damaged.
2. The heating surface is a high strength composite material. Please
use appropriate care in handling and cleaning.
3. Do not use steel wool, abrasive cleaners, or chlorinated cleaners on
the charger.
4. Wipe the entire charger off with a damp cloth and mild detergent.
Dry the charger before connecting it to its electrical source.
GREASE AND AIR FILTERS
1. Weekly, inspect the two bottom-mounted grease filters for build-up
of debris.
2. Slide filters out of their holders and run under faucet or in
dishwasher to clear of debris and grease. FILTERS MUST BE
DRY BEFORE SLIDING BACK INTO THEIR HOLDERS. DO NOT
OPERATE YOUR Turbo•Temp WITHOUT PROPERLY FITTED, DRY
FILTERS.
3. Replacement filters may be obtained by calling Dinex service.
!
WARNING: Never spray, wash or use excessive water on the
charger. Before cleaning it is absolutely necessary to unplug power
plug.
• Do not use the charger if the top is broken or cracked.
• Never use the charger as a work surface or cutting board.
• Never attempt to heat anything other than a Dinex
8x1-Series Smart base.
Turbo•Temp | 5