Aeotec MULTISENSOR 6 Руководство пользователя - Страница 4

Просмотреть онлайн или скачать pdf Руководство пользователя для Аксессуары Aeotec MULTISENSOR 6. Aeotec MULTISENSOR 6 8 страниц. Z-wave water and flood sensor
Также для Aeotec MULTISENSOR 6: Руководство пользователя (13 страниц), Руководство (3 страниц), Руководство (10 страниц), Руководство пользователя (13 страниц)

11/21/2017

3. Water is detected by sensing point 1 and 2.

4. Water is detected by sensing point 3 and 4.

5. Water is detected by sensing point 1, 2, 3 and 4.

These situations will cause Water Sensor 6 to send a water presence or trigger event to your gateway. Should water clear

from the area where Water Sensor 6 is installed, the sensor will also send a separate command to your Z-Wave gateway

informing it that there is no more water in the area.

Installing Dock for Water Sensor 6.

You can choose to install Water Sensor 6 on Dock for Water Sensor 6 for permanent power via USB and installation of

probes to extend the detection to different locations. You can follow the Dock for Water Sensor 6 user guide

(https://aeotec.freshdesk.com/solution/articles/6000176812-dock-for-water-sensor-6-user-guide-)

installation steps.

Additional information on other Gateways uses.

Smartthings Hub.

Smartthings hub has basic compatibility to the Water Sensor 6, it does not allow you to access its advanced configuration

functions readily. In order to make full use of your Water Sensor 6 to its fullest, you must install a custom device handler in

order to access other functions of the switch.

You can find the article for the custom device handler here: https://aeotec.freshdesk.com/solution/articles/6000184942-

water-sensor-6-smartthings-hub-device-handler-

sensor-6-smartthings-hub-device-handler-)

https://aeotec.freshdesk.com/support/solutions/articles/6000171886-water-sensor-6-user-guide-

Water Sensor 6 user guide. : Aeotec by Aeon Labs

(https://aeotec.freshdesk.com/solution/articles/6000184942-water-

to follow up with the

4/8