Ariston PRIMO HE ITD 300 Инструкция по установке и использованию - Страница 13

Просмотреть онлайн или скачать pdf Инструкция по установке и использованию для Водонагреватель Ariston PRIMO HE ITD 300. Ariston PRIMO HE ITD 300 24 страницы. Unvented hot water storage cylinders
Также для Ariston PRIMO HE ITD 300: Инструкции по установке, обслуживанию и эксплуатации (34 страниц)

Печатать страницу

www.tradeplumbing.co.uk Call Sales On 08708034288

prevent risk to the appliance's lifespan when disconnecting the protection

system for an extended period of time, it is necessary to drain the appliance

beforehand.

In addition to the 240V network, the electronic circuit is also connected to

the tank, which is to be protected, and to the titanium protection electrode,

INFORMATION FOR THE END USER

Proper operation of the protection system is shown by a continuous green

L.E.D, indicating that the circuits terminals are being supplied with electricity.

In the event of failure, a red L.E.D. indicates that there is a short-circuit

between the electrode and the cylinder tank, that one of the leads (tank or

electrode) is disconnected or that there is no water in the cylinder.

Your appliance is thus properly protected when the green L.E.D. is

illuminated and the red L.E.D. is off. Should this not be the case, please

contact your installer.

FITTING IMMERSION HEATER(S) (100 - 300 litre foor standing only)

These are supplied with but not fitted to 100 - 300 floor-standing models. A

sealing gasket is supplied with each element, however the use of a suitable

sealing compound is recommended to ensure a correct seal. Care must be

taken not to cross thread the immersion heater(s) when fitting. Each

immersion heater is supplied with a regulation thermostat and manual reset

thermal cut-out. This will activate if the regulation thermostat fails. Under no

circumstances should this be by-passed. The immersion heaters supplied

are rated at 3kW, there are 4kW upgrade kits available on request, (the part

number for which is 925392). Should the immersion heater(s) be ugraded to

the 4kW immersion, the electrical circuit and fuse must be checked to

ensure suitability with the higher output. Although the immersion heaters

are a standard 2

" thread, they must not be substituted with anything but an

original Ariston spare part.

OTE

HE IMMERSION HEATERS MUST NOT BE FITTED WITHOUT THE THERMOSTAT

THERMAL

CUT

OUT

DIRECT SYSTEMS

A mains supply of 240V, 3kW (13 amps) is required. Heat resistant cable,

round 3 or 4 core 2.5mm

(to BS6141 table 8) must be used to connect the

electrical supply through the Economy 7 time control switch using either

system 'A' or 'B' as illustrated in F

. 2.11.

SYSTEM A

SYSTEM B

. 2.11